Desa VSL18PT, LSL18PT Warranty Information, Keep this Warranty, Model Serial No Date of Purchase

Page 28

WARRANTY INFORMATION

KEEP THIS WARRANTY

Model

Serial No.

Date of Purchase

Always specify model and serial numbers when communicating with the factory.

We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or implied.

LIMITED WARRANTIES FOR NEW AND FACTORY

RECONDITIONED PRODUCTS

VENT-FREE RESIDENTIAL GAS HEATERS

New Products: DESA Heating Products warrants this heater and any parts thereof, to be free of defects in materials and workmanship for two (2) years from the date of first purchase, when operated and maintained in accordance with the manufacturer's instructions. These warranties are extended only to the original retail purchaser, when proof of purchase is provided.

Factory Reconditioned Heaters: DESA Heating Products warrants this factory reconditioned heater and any parts thereof, to be free of defects in materials and workmanship for thirty (30) days from the date of first purchase, when operated and maintained in accordance with the manufacturer's instructions. These warranties are extended only to the original retail purchaser, when proof of purchase is provided.

This warranty is extended only to the original retail purchaser. This warranty covers the cost of part(s) required to restore this heater to proper operating condition and an allowance for labor when provided by a DESA Heat- ing Products Authorized Service Center. Warranty part(s) MUST be obtained through authorized dealers of this product and/or DESA Heating Products who will provide original factory replacement parts. Failure to use original factory replacement parts voids this warranty. The heater MUST be installed by a qualified installer in accordance with all local codes and instructions furnished with the unit.

This warranty does not apply to parts that are not in original condition because of normal wear and tear or parts that fail or become damaged as a result of misuse, accidents, lack of proper maintenance or defects caused by improper installation. Travel, diagnostic cost, labor, transportation and any and all such other costs related to repairing a defective heater will be the responsibility of the owner.

TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURISDICTION THAT GOVERNS THE SALE OF THE PRODUCT; THIS EXPRESS WARRANTY EXCLUDES ANY AND ALL OTHER EXPRESSED WARRANTIES AND LIMITS THE DURATION OF ANY AND ALL IMPLIED WARRANTIES, INCLUD- ING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE TO TWO

(2)YEARS ON ALL COMPONENTS FROM THE DATE OF FIRST PURCHASE; AND DESA HEATING PRODUCTSʼ LIABILITY IS HEREBY LIMITED TO THE PURCHASE PRICE OF THE PRODUCT AND DESA HEATING PRODUCTS SHALL NOT BE LIABLE FOR ANY OTHER DAMAGES WHATSOEVER INCLUDING INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES.

Some states do not allow a limitation on how long an implied warranty lasts or an exclusion or limitation of incidental or consequential damages, so the above limitation on implied warranties or exclusion or limitation on damages may not apply to you.

This warranty gives you specific legal rights and you may also have other rights that vary from state to state. For information about this warranty write:

2701 Industrial Drive P.O. Box 90004

Bowling Green, KY 42102-9004 www.desatech.com

Patent Pending

Image 28
Contents What to do if YOU Smell GAS Table of Contents Safety Information Product Features Local CodesProduct Identification UnpackingAIR for Combustion Ventilation Providing Adequate VentilationFollowing are excerpts from National Fuel Unusually Tight ConstructionDetermining FRESH-AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceInstallation Ventilation AIRCheck GAS Type Ventilation Air From Inside BuildingLocating Heater Installation ItemsThis heater is designed to be mounted on a wall Installing Heater to Wall Attaching Mounting Bracket To Wall Is provided with heaterFor attaching mounting bracket to wall studs Placing Heater On Mounting BracketConnecting to GAS Supply Installing Bottom Mounting ScrewsImportant For natural gas, check gas line Tor damage could occurMin. Natural Gas Checking GAS ConnectionsPropane/LP Test Pressures In Excess Of 1/2 Psig 3.5 kPa Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPaEquipment Open Shutoff Valve Closed Gas Meter EquipmentConnecting to Electrical Supply For Your Safety Read Before LightingOperating Heater Extension CordLighting Instructions To Turn OFF GAS To ApplianceThermostat Control Operation Shutting Off HeaterManual Lighting Procedure Inspecting HeaterBurner Flame Pattern Pilot Flame PatternCleaning Maintenance Pilot Assembly Pilot Air InletODS/PILOT and Burner Burner Pilot AIR InletTroubleshooting Observed Problem Possible Cause RemedyGoes out when control knob is Control knob not pressed Delayed ignition of burner Manifold pressure is too lowBurner orifice is clogged Clean burner see Cleaning ODS/pilot lights but flameWalls or furniture Cleaners, etc. may turn into No power to electric outlet 60Hz outletSlight smoke or odor during Air passageways on heaterMent above Wiring Diagrams SpecificationsLSL18NT, SL18NT and VSL18NT LSL18PT, SL18PT and VSL18PT Accessories Technical ServiceReplacement Parts Service Publications Service HintsIllustrated Parts Breakdown Models LSL18NT, LSL18PT, SL18NT, SL18PT, VSL18NT and VSL18PTParts List Parts Centrals 116292-01A Warranty Information Keep this WarrantyModel Serial No Date of Purchase Industrial Drive P.O. Box Patent PendingQUÉ Hacer SI Percibe Olor a GAS Tabla DE Contenido Información DE Seguridad Información DE Códigos LocalesDesempaque Características DEL ProductoAire Para Combustión Ventilación Cómo Proveer LA Ventilación AdecuadaConstrucción inusualmente sellada Espacio confinado y no confinadoAire Para Ventilación Aire del interior de la construcción para ventilaciónVerifique EL Tipo DE GAS InstalaciónAire del exterior para ventilación Ubicación DEL Calentador Artículos DE InstalaciónEste calentador está diseñado para montarse en una pared Instalación DEL Calentador EN LA Pared Soporte de montajeDesmontaje del panel anterior del calentador Panel de vidrio Separador TornilloZando una broca de 9/64 de pulgada Con los orificios que perforó en la paredEn los maderos de la pared Doble el anclaje de pared como se muestra en la figuraConexión AL Suministro DE GAS Instalación de los tornillos de montaje inferioresQuite el calentador del soporte de montaje Calentador Pared SeparadorUnión T Unión terminal Buje reduc Tor a 1/8De pulgada Válvula de Con rosca Cierre del Tipo NPT Tapón EquipoCierre de Equipo Cerrada MedidorDe gas Tanque de suministro de propano o gas LP Válvula deFuncionamiento DEL Calentador Conexión a LA Alimentación EléctricaCable DE Extensión Para SU SEGURIDAD, LEA Esto Antes DE EncenderloInstrucciones DE Encendido Funcionamiento DELApague el piloto Funcionamiento DEL Patrón DE LA Llama DELCalentador Procedimiento DELimpieza Y Mantenimiento Piloto CON ODS Y QuemadorEntrada DE Aire AL Piloto DEL Quemador GabineteSolución DE Problemas Problema Observado Causa Posible RemedioLa posición del regulador de gas no es la correcta Reemplace el regulador de gasCausa Posible Remedio El problema desaparecerá Hay aire en la línea de gas Hasta que se elimine el aireLínea de gas Los conductos de aire en elCia anterior Diagramas DE Cableado EspecificacionesLSL18NT, SL18NT y VSL18NT LSL18PT, SL18PT y VSL18PTAccesorios Servicio TécnicoPublicaciones DE Servicio Piezas DE RepuestoClasificación Ilustrada DE Piezas Modelos LSL18NT, LSL18PT, SL18NT, SL18PT, VSL18NT Y VSL18PTLista DE Piezas Laporte’s Parts & Service 2444 N th Street Centrales DE PiezasNotas Información DE Garantía Guarde Esta Garantía