Desa SBJ24VPA, SMA18VNA, SMA24VPA Manual Lighting Procedure, Optional HAND-HELD Remote Operation

OPERATING HEATER

Continued

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, starting on page 16.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 17.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page

27). Follow instructions included with the remote control.

NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 16.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Flip AUTO/OFF/ON
switch to AUTO. Slide the selector switch to the
REMOTE position (see Figure 20). Note: The
burner may light if hand-held remote was on
when selector switch was last turned off. You
can now turn the burner on and off with the
hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
	Selector Switch in
Control Knob	REMOTE Position
		REMOTE
		OFF
		ON

ON/OFF SERIES (MODEL HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the con- trol button again until burner turns off (see Figure 21).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed

To Unlock press both buttons together on hand- held remote control until the light stops flashing. The hand-held remote is now unlocked.

Indicator	Control
	Button
Light

Figure 21 - On/Off Hand-Held Remote

Control Unit

THERMOSTAT SERIES (MODEL HRC200)

The hand-held remote can be operated using ei- ther the manual mode (MANU) or thermostatic mode (AUTO) (see Figure 22, page 19). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

Piezo Ignitor

Flame Adjustment Knob

Figure 20 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

18 www.desatech.com 114744-01C