Quadra-Fire MTVERNON-AE-CSB, MTVERNON-AE-PMH, MTVERNON-AE-MBK Through The Wall & Vertical Exterior

R

Mt. Vernon Pellet Stove (AE)

C. Vertical into Existing Class A Chimney

Rain Cap

	Flashing
	12 in. (305mm) Minimum
	Firestop
	6 in. (152mm) Class A
	Chimney Connector
	Adapter
	Ceiling Support
	3 in. (76mm) Min.
6 in.	3 to 6 in. (76-152mm)
(152mm)	Offset Adapter
Min.	3 to 3 in.
	(76-76mm)
	Top Vent Kit
	Clean-out Cover

Non-combustible Hearth Pad

Figure 15.1

We recommend a minimum of 60 inches (1524mm) vertical, however above the eave is preferred.

All three installations are approved for mobile home installations. Must use 3 or 4 inch (76 to 102mm) “L” or “PL” Listed pellet venting or Listed double wall pipe and Quadra-Fire Out- side Air Kit in mobile homes. Single wall pipe is approved for residential installations only.

*NOTE: Clearance to combustibles are for standard pellet pipe. If pellet pipe manufac- turer allows reduced clearances to their pipe, reduced clearances are allowed.

D. Through The Wall & Vertical - Exterior

	Rain
	Cap
Flashing	12 in.
	(305mm)
	minimum
2 in. (51mm) minimum	Support
	Bracket
	every 60 in.
6 in. (152mm)	(1524mm)
minimum	Wall Thimble
	Tee
	Clean-out
	Cover
Non-combustible Hearth Pad

Figure 15.2

E. Vertical - Interior - Typical Installation

Rain Cap

	Flashing	12 in.
		(305mm)
		Minimum
	Firestop
6 in.		3 in. (76mm)Min.
(152mm)
Min.		3 in. to 3 in.
		(76-76mm)
		Top Vent Kit
		Clean-out Cover

Non-combustible Hearth Pad

Figure 15.3

September 1, 2008 7034-106E Page 15