Quadra-Fire MTVERNON-AE-CWL, MTVERNON-AE-PMH Mt. Vernon Pellet Stove AE Quick Start Guide

R

Mt. Vernon Pellet Stove (AE)

H. Quick Start Guide

NOTICE: Any button pressed will turn on the backlight. Wall control will automati- cally revert back to the starting screen if there is no activity for 15 seconds; except for the “CONFIRM FUEL CHANGE” screen.

CHOOSING FUEL TYPE

R A P

Set at

MENU

1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.

MENU

Set Comfort Level

A to/ an al/ ff

Fuel Type

ser Settings

2.Highlight “FUEL TYPE” using the “UP/ DOWN” buttons to the right side of the display. Press “SELECT”.

F L S L C

Soft ood Pellet

S nflo er Seeds heat

ard ood Pellet

3.Scroll down and highlight “HARD- WOOD PELLET” or your fuel type.

4.Now press “SELECT” to choose new fuel

C F R	F	L C A
Please empt		hopper
of old f	el t	pe and
ens re fire o		is lean
Please refer to
se tion	in man al
DONE

5.Press “DONE” to confirm fuel change.

6.Press “DONE” twice or wait 15 sec- onds for starting screen to reap- pear.

7.Fill the hopper with fuel, and if the hopper was completely empty, or has run out of fuel, throw approximately 1/2 cup of pellets into the firepot.

8.Be sure the hopper lid and glass door are both closed.

		ttons
	R A	P	Up
Room		Set at
			Down
Temp	MENU	HEAT OUTPUT

Function Buttons

Wall Control for Reference

TURNING ON APPLIANCE

R A P

Set at

MENU

1.At the starting screen, press “MENU”.

Set Comfort Level

A to/ an al/ ff

F el pe

ser Settings

2.Highlight “AUTO/MANUAL/OFF”. Press “SELECT”.

A/AAL SS

Atomati

an al ff

3.Highlight “MANUAL”. Press “SELECT”.

4.Press “DONE” twice or wait 15 seconds for starting screen to reappear.

CHOOSING TEMP UNIT:

°F or °C

R A P

Set at

MENU

1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.

Set Comfort Level

A to/ an al/ ff

F el pe

ser Settings

2.Highlight “USER SETTINGS” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.

S R S S

emp nits F/C Flame eight Ad st

emp ifferential

2.Highlight “TEMP UNITS F/C” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.

3.Press the “UP” or “DOWN” button to set desired temperature unit and press “SELECT”..

4.Press “DONE”. Press “DONE” again, or wait 15 seconds for starting screen to reappear.

Page 26 7034-106E September 1, 2008