R
Mt. Vernon Pellet Stove (AE)
1 Listing and Code Approvals
A. Appliance Certification
Model | Mt. Vernon Pellet Stove AE |
Laboratory | OMNI Test Laboratories, Inc. |
Report No. | |
Type | Solid Fuel Room Heater/Pellet Type |
Standard | ASTM |
| |
| Pellet Fuel Burning type and (UM) 84- |
| HUD, Mobile Home Approved. |
FCC | Complies with Part 15 of FCC Rules. |
| Operation is subject to the following |
| two conditions: (1) this device may not |
| cause harmful interference, and (2) this |
| device must accept any interference |
| received, including interference that |
| may cause undesired operation. |
E. BTU & Efficiency Specifications
Emissions Rating: | EPA Compliance |
*BTU Output: | 14,620 - 60,200 |
Efficiency: | 81.4% - 83.6% |
Heating Capacity: | 2,400 - 3,800 square feet depend- |
| ing on heating zone |
Hopper Capacity: | 81 lbs |
Fuels: | Pellets, Shelled Field Corn, Wheat |
| and Black Sunflower Seeds |
Shipping Weight: | 429 lbs |
*BTU output will vary, depending on the type of fuel you use in your stove. Consult your
B. Mobile Home Approved
This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained. The appliance must be properly grounded to the frame of the mobile home and use only listed pellet vent Class “L” or “PL” connector pipe. A
NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.
C. Glass Specifications
This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.
NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the
ASTM E1509, ULC
D. Electrical Rating
115 VAC, 60 Hz, Start 5 Amps, Run 1.25 Amps
Page 4 | September 1, 2008 |