R
Mt. Vernon Pellet Stove (AE)
3.Auto / Man - L, ML, M, MH, H (Cont’d)
You can operate the appliance from any of the 5 levels. On the lowest level, the appliance will stay on longer, burn less fuel per hour, but will take longer to bring the home up to your desired temperature. On the highest setting, the appli- ance will burn more fuel per hour, but bring your home up to temperature more quickly.
Regardless of the heat output level, when the home reaches your set temperature, the appliance will go into the shut down cycle. In Manual mode heat output does not change. Turn to OFF to stop operation.
4.Shutdown
Once your home has reached your set temperature, the appliance will stop feeding fuel and allow the fire to dimin- ish. The convection blower will continue to run until the appliance cools to appropriate temperature and will go into the
5.Auto-Clean
The firepot
•When the house reaches temperature and the appli- ance shuts down.
•At prescribed intervals, depending on the type of fuel selected.
If your appliance is running and the
The floor of the firepot will open and deposit the ash into the ash pan. It takes approximately 2 minutes to complete the
During this
WARNING
Fire Risk
Do NOT operate appliance:
•With appliance door open.
•With Firepot floor open. Do NOT store fuel:
•Closer than required clearances to com- bustibles to appliance.
•Within space required for loading or ash removal.
WARNING
Fire Risk
Keep combustible materials, gasoline and other flammable vapors and liquids clear of appliance.
•Do NOT store flammable materials in the appliance’s vicinity.
•Do NOT use gasoline, lantern fuel, kerosene, charcoal lighter fluid or similar liquids to start or “freshen up” a fire in this heater.
•Keep all such liquids well away from the heater while it is in use.
•Combustible materials may ignite.
Additional Screen Messages:
READY It is telling you that the home is up to temperature and does not need any heat.
-- - - - The screen will show 5 dashes when the wall control and the control board are NOT communicating with each other. Check that the wiring on the thermostat is prop- erly connected.
MAINTENANCE BURN The maintenance burn is to keep the system from shutting down when operating on battery backup. The appliance will not automatically
OFF The AUTO/MANUAL SETTING screen has been set to OFF. Set the appliance to OFF when performing periodic maintenance to prevent an unexpected startup.
September 1, 2008 | Page 25 |