Majestic Appliances 360DVSL, 360DVSR, 360DVS3 warranty General Venting, Electronic Gas Control Valve

Electronic Gas Control Valve

This appliance may be fitted with a Honeywell ignition module.

Installation of the remote ON/OFF starter switch on electronic ignition units (Fig. 12):

1.Thread the wiring through the holes on the side panels of the appliance. Take care not to cut the wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the switch into the receptacle box.

3.Connect the white wire from the wall switch to the black wire from the transformer, using an approved wire nut. Connect the black wire from the wall switch to the black wire running from the #6 position of the ignition module, also using an approved wire nut.

360DVS Series Direct Vent Fireplaces

		PILOT
			HONEYWELL IGNITION MODULE
	MV	MV/VP	PV	24V	24V	SENSE SPARK
				GRD
	1	2	3	5	6	8	9
	RED			GREEN			BLACK
	ORANGE	ORANGE
			HI
			NOVA SIT 822 VALVE				BLUE
	WHITE
	POWER CORD
	W/FEMALE SPADE
	120 VAC RTN	24 VAC HOT					BLACK
	WHITE		BLACK				OFF
							WHITE
	BLACK		YELLOW
	GREEN
	120 VAC HOT	24 VAC RET
	40VA TRANSFORMER						WALL SWITCH
					BLACK		WHITE
							FP1225
Fig. 12	Honeywell ignition module.

General Venting

Your fireplace is approved to be vented either through the side wall, or vertically through the roof.

•Only CFM Corporation venting components, specifi- cally approved and labeled for this fireplace, may be used.

•Venting terminals shall not be recessed into a wall or siding.

•Horizontal venting must be installed on a level plane without an inclining or declining slope.

There must not be any obstruction such as bushes,

garden shed, fencing, deck or utility building within 24” (610mm) from the front of the termination hood.

Do not locate the termination hood where excessive snow or ice buildup may occur. Be sure to check the vent termination area after snow falls; clear it to prevent accidental blockage of the venting system. When using a snow blower, make sure snow is not directed toward the vent termination area.

Location of Vent Termination

It is imperative the vent termination be located observ- ing minimum clearances as shown on the following page.

10006326 13