360 DVS Series Direct Vent Fireplaces
Wiring Instructions
The fireplace, when installed, must be elec- trically connected and grounded in accor-
dance with local codes, or in the absence of local codes, with the current CSA C22.1 Canadian Electric Code. For USA installa- tions, follow local codes and the National Electrical Code
ANSI/ NFPA No. 70.
Any electrical rewiring of this fan must be done by a licensed electrician.
Should this fan require servicing or repair, the power supply must be disconnected. For rewiring of any replacement parts, refer to Figure 51.
Method A (Not using
1.Connect the ground wire to the power supply line to ground stud located on the base of the firebox.
2.Connect the black wire of the supply line to either terminal of the speed control unit.
3.The second terminal of the speed control unit is attached to either terminal of the thermal sensor.
4.The second terminal of the thermal sensor is con- nected to either terminal of the fan motor.
5.The second fan motor terminal is connected to the white wire of the supply line.
A: Speed Control
B: Temperature SensorC
C: Fan
B
A
Black
White
Ground
Decorative Trim Frame Kit
The DV360TKMP Medium Trim Kit in polished brass is available for the 360DVS2 model only.
Each kit contains 4 polished brass trim pieces and the necessary attaching screws to frame one side window of the unit.
Installation (Refer to Fig. 53)
1.Remove the top louvre assembly.
2.Lower the bottom louvre assembly to expose the lou- vre hinges. Unscrew the retaining screws and remove the louvre assembly from the hinges.
3.Remove the retaining screws that secure the top deflector plate (above the top louvre opening), and remove the plate.
Trim - top
| Screws |
|
S |
| S |
| c | |
c | Trim Window Top/Bottom | r |
r | e | |
e |
| w |
w |
| s |
s |
|
|
Screws | ||
|
Trim - bottom
Top trim piece
CFM105
FP1449
Top deflector plate
Fig. 52 Method ‘A’ fan wiring diagram.
Method B
For instruction on wiring the
Remote Controls
Optional remote control units are available to control dif-
ferent functions of the appliance.
Model | Function(s) Controlled |
RC1 | ON/OFF |
RC2 | ON/OFF & Temperature |
IMTFK |
Fig. 53 Decorative trim frame installation.
4.Using the screws provided, attach the lower trim piece to the predrilled holes in the lower edge of the bottom louvre opening.
5.Using the screws provided, attach the two side trim pieces to the predrilled holes in the vertical side frames.
6.Use the top deflector plate and the screws removed in step 3 to clamp the top trim piece in place. With the trim piece in place along the top edge, refit and secure the top deflector plate.
7.Reattach the lower louvre panel to the hinges and re- place the top louvre assembly.
All protective plastic wrap must be removed from the trim pieces before the appliance is
put into service. If plastic wrap is not re- moved, a health or fire hazard may develop.
40 | 10006326 |