Axis Communications P5544 user manual Media Streams, How to Stream H.264, Axis Media Control AMC

Page 13

AXIS P5544 PTZ Dome Network Camera

Media Streams

Media Streams

The Axis product provides several audio and video stream formats. Your requirements and the properties of your network will determine the type you use.

The Live View page in the product provides access to H.264 and Motion JPEG video streams, audio streams and to the list of available stream profiles. Other applications and clients can access video and audio streams directly, without going via the Live View page.

How to Stream H.264

The video compression standard H.264 makes good use of bandwidth, and can provide high quality video streams at less than 1 Mbit/s.

Deciding which combination of protocols and methods to use depends on your viewing requirements, and on the properties of your network. The available options in AXIS Media Control are:

Unicast RTP

This unicast method (RTP over UDP) is used

 

 

for live unicast video, especially when it is

 

 

important to always have an up-to-date video

 

 

stream, even if some images are dropped.

Unicasting is used for video-on-demand

RTP over RTSP

This unicast method (RTP tunneled over RTSP)

transmission so that there is no video traffic

on the network until a client connects and

 

is useful as it is relatively simple to configure

 

requests the stream.

 

firewalls to allow RTSP traffic.

 

Note that there are a maximum of 20

 

 

RTP over RTSP over HTTP

This unicast method can be used to traverse

simultaneous unicast connections.

 

firewalls. Firewalls are commonly configured to

 

 

allow the HTTP protocol, thus allowing RTP to

 

 

be tunneled.

 

 

 

 

Multicast RTP

This method (RTP over UDP) should be used for live multicast video. The video stream is always

 

up-to-date, even if some images are dropped.

 

 

Multicasting provides the most efficient usage of bandwidth when there are large numbers of

 

clients viewing simultaneously. A multicast cannot however, pass a network router unless the

 

router is configured to allow this. It is not possible to multicast over the Internet, for example.

 

Note also that all multicast viewers count as one unicast viewer in the maximum total of 20

 

simultaneous connections.

 

 

 

 

AXIS Media Control negotiates with the Axis product to determine the transport protocol to use. The order of priority, listed in the AMC Control Panel, can be changed and the options disabled, to suit specific requirements.

Note

H.264 is licensed technology. The Axis product includes one H.264 viewing client license. Installing additional unlicensed copies of the client is prohibited. To purchase additional licenses, contact your Axis reseller.

MJPEG

This format uses standard JPEG still images for the video stream. These images are then displayed and updated at a rate sufficient to create a stream that shows constantly updated motion.

The Motion JPEG stream uses considerable amounts of bandwidth, but provides excellent image quality and access to every image contained in the stream. The recommended method of accessing Motion JPEG live video from the Axis product is to use the AXIS Media Control in Internet Explorer in Windows.

AXIS Media Control (AMC)

AXIS Media Control (AMC) in Internet Explorer in Windows is the recommended method of accessing live video from the Axis product.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Axis P5544 PTZ Dome Network Camera About This Document SafetyLiability Intellectual Property RightsAxis P5544 PTZ Dome Network Camera Table of ContentsPerformance Considerations Hardware Overview ConnectorsHardware Overview For technical specifications, seeMidspan LED Indicators LED IndicatorsColor Indication Accessing the Product Accessing the ProductAccess from a Browser Start a browser Internet Explorer, Firefox, SafariSet the Root Password Access from the InternetNetwork TCP/IP Advanced Click Create self-signed certificateLive View Overview ModeNormal Mode Controls on the Live View Go to Overview modeAudio Controls Manual Trigger Go to Setup EventsTo show the manual trigger buttons in the Live View Media Streams How to Stream H.264Media Streams Axis Media Control AMCQuickTimeTM. The following paths can be used Alternative Methods of Accessing the Video StreamJava applet supports simplex audio with G.711 encoding Accessing Audio StreamsSetting Up the Product Setting Up the ProductBasic Setup Video and Audio Video and AudioVideo Stream Pixel CounterStream Profiles Click Save to apply the new settingsImage 264Exposure Settings Camera SettingsImage Appearance White BalanceOverlay Image SettingsOverlay Image Go to Video & Audio Video Stream and select the Image tabPrivacy Mask Audio SettingsAudio Modes Audio InputG711 G726 Audio OutputAudio Clips Live View Config Default Viewer for BrowsersLive View Config Go to Setup Live View Config Viewer SettingsUser Defined Links Output ButtonsAxis P5544 PTZ Dome Network Camera PTZ Pan Tilt Zoom Preset PositionsPTZ Pan Tilt Zoom GatekeeperOsdi Zones Guard TourAdvanced LimitsControl Queue Operator Same as administrator but with lower priorityControls Detectors Set Up Motion Detection WindowsDetectors Motion DetectionMotion Detection Parameters Audio DetectionApplications ApplicationsEvents EventsPTZ Control Setting Up an Action RuleGo to Events Action Rules and click Add Schedules RecipientsRecurrences Axis P5544 PTZ Dome Network Camera Recordings RecordingsRecording List Continuous RecordingAxis P5544 PTZ Dome Network Camera System Options System OptionsSecurity UsersIeee Date & TimeAudio Support Network Basic TCP/IP SettingsIPv4 Address Configuration IPv6 Address ConfigurationAdvanced TCP/IP Settings NAT traversal port mapping for IPv4 Link-Local IPv4 AddressSmtp email QoS Quality of ServiceUPnPTM StorageRTP/H.264 BonjourGo to System Options Storage and click SD Card Network ShareGo to System Options Storage Click Network Share Ports & Devices MaintenancePorts Port StatusSupport Open PTZ Calibration from System Options MaintenanceSupport Overview System OverviewScripting Reset to Factory Default SettingsFile Upload Plain ConfigMulti-Connector Cable sold separately Multi-Connector Cable sold separatelyFunction Pin Specifications DC power input Connection diagramTroubleshooting TroubleshootingEmergency Recovery Procedure Checking the FirmwareProblems setting the IP address Symptoms, Possible Causes and Remedial ActionsProduct cannot be accessed from a browser Problems with the H.264 format Product is accessible locally but not externallySetup Video & Audio Camera Settings Video and image problems, generalPTZ problems Problems uploading filesStorage and disk management problems SettingsMotion Detection triggers unexpectedly No audioTechnical Specifications Technical SpecificationsMemory Power Maintenance Installation aidsConnectors Function/group Specifications Network SecurityPerformance Considerations Ver M1.15 Axis P5544 PTZ Dome Network Camera

P5544 specifications

The Axis Communications P5544 is a robust and versatile network camera designed for high-performance surveillance in various environments. With its advanced features and cutting-edge technologies, it provides exceptional video quality and reliability, making it a popular choice for businesses and organizations looking to enhance their security systems.

One of the standout features of the P5544 is its high-resolution imaging capabilities. The camera offers 720p HD video quality, ensuring clear and detailed footage, even in challenging lighting conditions. This high resolution is particularly beneficial for capturing essential details such as faces or license plates, which can be crucial in security scenarios.

The P5544 is equipped with a powerful zoom lens, allowing users to zoom in on specific areas of interest without compromising image quality. With a 22x optical zoom, operators can easily focus on distant subjects or wide scenes, providing flexibility in monitoring various locations. This feature, combined with the camera's pan and tilt functionality, enables comprehensive coverage of a designated area.

In addition to its impressive optical capabilities, the Axis P5544 incorporates advanced image enhancement technologies. It features Axis' Wide Dynamic Range (WDR) technology, which helps in handling difficult lighting conditions, such as bright sunlight and deep shadows. This ensures that video footage remains clear and detailed in various lighting scenarios, enhancing overall situational awareness.

The camera is designed for durability and adaptability, making it suitable for both indoor and outdoor use. It is housed in a rugged casing that meets IK10 vandal resistance standards, providing protection against physical damage. This robustness ensures that the camera can endure harsh weather conditions, making it a reliable option for various installations.

Moreover, the Axis P5544 supports Power over Ethernet (PoE), simplifying installation by requiring only a single cable for power and data transmission. This not only reduces the complexity of the setup but also contributes to a cleaner and more organized deployment.

In conclusion, the Axis Communications P5544 is a powerful surveillance tool that combines high-definition imagery, versatile zoom capabilities, advanced image processing, and a durable design. Its features make it an ideal choice for businesses seeking reliable security solutions that can adapt to various environments and challenges. With the P5544, organizations can enhance their monitoring capabilities, improving overall safety and security.
Top Page Image Contents