Bosch Appliances D9412GV2 manual 14.2 D7412GV2 Faceplate

D9412GV2/D7412GV2 Operation and Installation Guide 14.0 Faceplates

14.2D7412GV2 Faceplate

Figure 33: D7412GV2

1

2

3

4

5

F01U003799B

LEDs Off When Normal				D7412GV2
YEL	Charging Status
				Digital Alarm Communicator Transmitter			SDI Connector
	Low Battery - 12.1 VDC
RED			Refer to D9412GV2/D7412GV2 Approved Applications Compliance Guide (P/N: F01U003639___)						11
				For System Wiring Diagram, Issue A			Reset Pin
10.2 VDC - Battery Load Shed			Refer to D9412GV2/D7412GV2 Approved Applications Compliance Guide (P/N: F01U003639___)			Disable All Except Battery
						Charging And Programming
				For Compatible Smoke Detectors
	CLASS 2 TRANSFORMER			POWER SUPPLY REQUIREMENTS		PERIPHERAL DEVICE CONNECTIONS
				The Power Supply provides a maximum of 1.4 Amps for the Control Panel and all		RED	POWER +
	16.5 VAC 40 VA 60 Hz			Accessory Devices. For System Loading, refer to D9412GV2/D7412GV2
	Model D1640			Operation and Installation Guide (P/N: F01U003641___).
	Internally Fused - Do Not short			All external connections except Terminal 5 (battery positive) are inherently power
	Requires Unswitched Outlet					YELLOW	DATA BUS A
	Do Not Share With Other Equipment			limited. Requirements for battery standby time might reduce allowable output.
	+ AUX POWER			CAUTION: See D9412GV2/D7412GV2 Operation and Installation Guide		GREEN	DATA BUS B
				(P/N: F01U003641) for Power Requirements relating to Terminals 6 and 7 .
	BATTERY NEGATIVE ONLY			WARNING!	Battery: Replace every 3 to
	CAUTION: Avoid damage to Panel.			Multi-Battery installation requires		BLACK	COMMON
	Do not connect 24 V to terminals.			Model D122/D122L Dual Battery	5 years with one or two Model
	Maximum charging current 1.4 A			Harness. Improper installation can	D126 12V 7Ah or D1218	N.F.P.A.	ZONEX OUT 1
	BATTERY POSITIVE ONLY			be a fire hazard.	12V 18Ah Lead Acid Batteries.
						Style 3.5
				This equipment should be installed in accordance with the NFPA 70 (National Electrical Code)		Signaling
	RELAY A	PROGRAMMABLE				Line
		ALARM OUTPUTS		and NFPA 72 (National Fire Alarm Code) for Local, Central Station, Remote Station, Proprietary and		Circuits	ZONEX IN 1
		Terminals		Household Fire Warning Systems and under the limits of the Local Authority Having Jurisdiction
	RELAY B	6 and	7	(National Fire Protection Association, Battermarch Park, Quincy, MA 02269). Printed information			NOT USED	26
				describing proper installation, operation, testing, maintenance, evacuation planning and repair
		SWITCHED AUX		service is to be provided with this equipment.
	RELAY C	Terminal		D7412GV2 Control/Communicator is UL Listed for Central Station, Local, Remote Station and			NOT USED	25
		8		Household Fire Alarm, and Central Station, Local, Police Station Connect, Household Burglar Alarm

and Encrypted Line Security when communicating via a network.

	System is intended to be checked by a Qualified Technician at least every 3 years.	ZONEX POWER + 24
COMMON	The types of initiating circuits for which the control panel has been approved are A, M, W, SS.

	VOLTAGE RANGES
EARTH GROUND	Open	3.7 - 5.0 VDC	ZONEX COMMON	23
	Normal	2.0 - 3.0 VDC
	Short	0.0 - 1.3 VDC

GROUND FAULT DETECT			Point 1 Point 2	Point 3 Point 4	Point 5 Point 6	Point 7 Point 8	Point 8	D5200/D5360
	Enabled
							S3 Option	PROG CONN
	Disabled
								10
		ON when					Closed = 1KΩ EOL
RED	PHONE	communicating					Normal Operation
	LED	OFF when idle					Open =AB-12 UL
	PHONE LINE SEIZED
							Bell Box 220 KΩ
TIP	TELCO CORD RING		11 12 13	14 15 16	17 18 19	20 21 22	GRN
	MODEL D161

PHONE LINE
SEIZED
TIP	RING
	TELCO

6

789

1 - Charging status LED (yellow)		7 -	Point 8 ground fault detect enable/disable
2 - Low battery LED (red)		8-	Operation monitor LED (green)
3 -	Color-coded battery leads	9-	Accessory connector
4 - Ground fault detect enable		10-	Programming connector
5 -	Phone LED (red)	11-	Reset pin
6 - Telephone cord connector

Bosch Security Systems, Inc. 5/05 F01U003641B 63