RAID Subsystem
Power Socket |
| Power Socket |
Power Switch |
|
|
| Power Switch |
Fig. 6.11 Power Sockets and Power Switches
3.Remove the PSU retention screw at the top
Fig. 6.12 Removing the PSU Retention Screw
4.Remove the PSU module by pressing down the PSU handle found on the top of the PSU. (See Figure 6.13) This will dislodge the PSU module from the subsystem.
PSUHandle
Fig. 6.13 Pressing Down the PSU Handle
5.After the PSU module has been dislodged from the enclosure, use the handle to gently pull the PSU module out of the enclosure. (See Figure 6.14)
Fig. 6.14 Dislodging the PSU
6.Remove the cooling module from the lower level of the PSU module. Please refer to Section 6.6 Cooling Module Maintenance.
CAUTION!
•
•
When a PSU is pulled out of the chassis, the cooling module beneath the PSU is removed from the chassis at the same time.
It is recommended that the replacement procedure is completed in less than five (5) min- utes to prevent the subsystem from overheating.
Bosch Security System | F.01U.027.799 V2 2008.08 |