H3010REV0608 NO LEAD:Digital Humidifier Manual 2L 6/16/08 1:25 PM Page 4
DIRECTIONS FOR USE IN NORMAL MODE (NO TIMER)
1.Power Button
Before turning on make sure there is water in the unit.
Press the Power Button.
DIRECTIONS FOR USE IN PROGRAMMABLE MODE
The programmable mode allows you to set the timer to turn the humidifier both on/off at a daily predetermined time. This mode also allows the clock to be programmed.
Power
Select/Set
Start |
Stop |
Time |
Done
set
Hour
r
Minute
Sp
C
Cool/Warm
2.Cool or Warm Humidification Button
Press to select cool or warm humidification. Water temperature is maintained at room temperature for cool setting and 80 degrees for warm.
WARM COOL
Program Start
1.Push and hold Select/Set Button until “Start” is blinking on display.
2.While “Start” is blinking, select desired start time using Hour and Minute buttons (am or pm as indicated).
3.Select Cool/Warm preference.
4.Select Spray Control preference.
5.“Start” indicator will remain lit once programmed.
|
| 3. Spray Control Button |
| Dim | When you press the Spray Control Button |
| there are four options to choose from: | |
|
| |
|
| Press once for weak |
|
| Press twice for middle |
Spray |
| Press three times for strong |
| Press four times for turbo | |
Control |
| |
|
| * You will notice the lights get higher as the spray increases. |
|
| 4A. Light Options - Display Button |
|
| Press the Display Button to turn the display lights on or off. |
Display
On/Off
4B. Light Options - Night Light Feature
Press the Lamp Button at the top of the unit to illuminate the night light feature.
Lamp
5.Water Refill Button
When the Water Refill Button lights up it is time to refill the water tank.
Program Finish
1.Push and hold Select/Set Button until “Stop” is blinking on display.
2.While “Stop” is blinking, select desired end time using Hour and Minute Buttons (am or pm as indicated)
3.“Stop” indicator will remain lit once programmed.
Clock Set
1.Clock must be set in order for timer to work properly.
2.Push and hold Select/Set Button until “Time” is blinking on display.
3.Select actual time using Hour and Minute Buttons (am or pm as indicated).