New Buck Corporation 34 manual To Turn OFF GAS to Appliance, Shutting OFF Unit

Page 15

•If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.

IGNITOR ELECTRODE

THERMO--COUPLEPILE

PILOT BURNER

12. Turn control knob counterclockwiseto the “ON” position. Push the “ON/OFF” toggle switch to the “ON” position. The main burner should light.

13.Close access panel door.

14.Turn on all electrical power to the appliance.

NOTE: This unit may be used with an optional Wall Thermostat. If so, the Wall Thermostat needs to be set at a higher temperature than the room temperature.

TO TURN OFF GAS TO

APPLIANCE

SHUTTING OFF UNIT

1.Open access panel door located at bottom front of the appliance.

2.“If equipped with thermostat set to lowest setting.”

3.Turn control knob clockwise to the “OFF” position.

4.Turn off all electric power to the appliance if service is to be performed.

5.Close access cover door.

SHUTTING OFF BURNER ONLY (Pilot stays lit.)

Turn control knob clockwise		to the “PILOT” position.

13

Image 15

Contents Model Page Table of Contents Model Page Section I Safety Information Warnings Page Page Fireplace Preparation SectionGAS Connection Installation and ClearancesPage Millivolt only Millivolt SIT MANUAL-MODULATING GAS Pressure CheckWhat to do if YOU Smell GAS Rocker Switch ITT Valve Shutting OFF Unit To Turn OFF GAS to ApplianceThermostat Control Operation Manual Lighting ProcedureLighting Instruction Modulating Valve SIT Manual Valve SIT For Your Safety Read Before LightingLighting Instruction Page Thermostat Control Operation Operating Instructions Page Page Manual Lighting Procedure B. LOG SET When Used AS a Heating Appliance Heat OutputFlame Check CR3329 LOG SETWiring Diagram Room Blower Installation and Operation Instructions Ceiling Page Page Page Drafts Section V Model 34 ZC Zero Clearance InstallationChoosing the Location for Your Fireplace GAS LineGAS Line Fireplace Clearances ZC Installing the Firebox ZCClearances ZC Finishing Your Fireplace ZCSection After Market Mobile Home Installation Producing Adequate Ventilation Determining FRESH-AIR Flow for Heater LocationDetermine if YOU have a Confined or Unconfined Space Determine the volume of the space length x width x height Ventilation AIR from Inside Building Ventilation AIRVentilation AIR from Outdoors Cleaning Important SafeguardsSolution Observed Possible Problem CauseObserved Possible Problem Solution Observed Possible Problem Cause Solution Observed Possible Problem Cause Solution Servicing Repair PartsReplacement Parts OFF PO 385BINIP PE RV20LF90PE RV20LF35 PO 382BINIPTSi Orifice PO Orifice Orifice Holder PO 54ORFHLD NUT & Sleeve Replacement PartsS Pilot NAT. O.P. Assembly MF 31621ALMTUBSIT Millivolt Replacement Parts for Ember Stove Base ESB ESB Warranty does not Cover Limited Warranty VENT-FREE GAS LOG Heater