SECTION II
FIREPLACE PREPARATION
The fireplace needs to be prepared before installing the heater.
A.Turn off the gas supply to the fireplace.
B.Read the following sections before installing your unit; Section III, page 26 Installation In A
NOTE: ”IF THE FACTORY BUILT FIREPLACE HAS NO GAS ACCESS HOLE(S) PROVIDED, AN ACCESS HOLE OF 1.5 inch (37.5mm) DIAMETER OR LESS MAY BE DRILLED THROUGH THE LOWER SIDES OR BOTTOM OF THE FIREBOX IN A PROPER WORKMANLIKE MANNER. THIS ACCESS HOLE MUST BE PLUGGED WITH
REFRACTORY, GLASS DOORS , SCREEN RAILS, SCREEN MESH AND
6