Vault vibration sensors are sophisticated electronic sensors that are sensitive to occupant and construction vibrations. If construction is scheduled to end by the programmed "Latest Close Time," use the Bypass VVS feature to automatically bypass ALL VVS detectors. ALL VVS detectors will be automatically unbypassed after 12 midnight. Complete steps 1 through 6 under Bypassing Protection Points. Then perform the following steps:
System Operation (cont’d)
7.Press Bypass VVS or Unbypass VVS to bypass or unbypass vault vibration sensors.
8.Press Quit to display Action Menu 3.
Extending Close Time
Fifteen minutes prior to the scheduled close time, the operating panel will beep once per minute to remind you to close (turn on burglary protection). If you are unable to turn on the burglary protection, you must extend the close time. Extending the close time (temporary schedule change) will override the permanent close schedule for one day only. It will be automatically deleted at midnight of the day it was entered. To extend the close time, perform the following steps:
1.Using the operating panel’s numeric keypad, enter a valid ID code that has been assigned the privilege level of "Can change temp sched."
2.Press More to display Action Menu 2.
3.Press Change close time to display Burglary group descriptions.
4.Press Previous or Next to display the specific Burglary group description.
5.Press the “Group description” button to display the current and new close times.
6.Using the operating panel’s numeric keypad, enter the new close time.
7.Press AM or PM to complete your entry and to display the new close time.
8.Press Quit to display the Time Selection Menu.
–69 –