HOW to Turn OFF the Fire

10Operation

Air Shutter Adjustment

15.Set the High-Low Regulator to desired setting: Turn fully counterclockwise for High and fully clockwise for Low.

NOTE: An odor, resulting from the initial heating of new materials in your heater, is not unusual during the ﬁrst ﬁre, and in most cases will disappear after an hour or two.

1.If using optional thermostat, set thermostat to the lowest position.

2.Turn off the electric power to the appliance.

3.Turn the ON-OFF/THERMOSTAT switch to the OFF position.

4.Push in the gas control knob slightly and turn it clockwise to “OFF.”

NOTE: The knob cannot be turned from “PILOT” to “OFF” unless it is pushed in slightly. Do not force it.

Normal Flame pattern. Note: Flames will vary in height and position depending on the placement and the amount of ember wool.

Pilot Flame Size

AIR SHUTTER ADJUSTMENT

The adjuster can be accessed with a phillips screw driver just above the valve . Turn the adjuster clockwise to increase ﬂame height and counterclockwise to de- crease. See above left. Adjusting the ﬂames too high will cause them to have black tips and cause sooting. Sooting can cause the glass to get dirty.

Warning: The unit and adjuster may be hot. Wear gloves and arm protection if making adjustments while in operation.

PILOT FLAMES

If pilot ﬂames are less than shown at left, have your service technician increase the pilot ﬂame height.

Spark

Pilot

Ignitor

Electrode

Pressing the ignitor button should produce a spark between the ignitor electrode and the pilot where shown above.