Harman Stove Company XL Main Burner will not light with valve in on position, Light pilot

Page 33

Trouble Shooting 33

Main Burner will not light (with valve in “on” position)

Is Pilot lit

no

Yes

Light pilot

Check Thermopile voltage at terminals marked

TP on valve. Should be too low approximately 200 mv

with switch “on” and approximately 400 mv with switch “off”.

Replace Thermopile

OK

Check switch, wires, and	bad
Check switch, wires, and
wiring connectors.

OK

Replace valve

Correct problem

Image 33

Contents Direct Vent Gas Fireplace Insert ShadowLight XLAdvetissement Quinconque ne respect pas Table of Contents Introduction Speciﬁcations Speciﬁcations Ratings Natural Propane Door Handles OperationOperation HOW to Turn OFF the Fire Inside the Insert Box Inside Face Box Packing ListInstallation Gas Pressure Requirements Making The ConnectionNatural Gas LP GasThese kits are only for use ShadowLight XL Insert Converting to Natural GasBurner Pilot Installation Converting to High Altitude Use Only Approved Venting VentingFlashing Chimney Cap ComponentsVenting and Installation Flue Installation Installation Check List Remote Control Connecting Optional ThermostatCleaning the Log Set and Firebox Cleaning the GlassReplacing the Glass and Gasket Removing the Glass DoorReplacing The Blower Cleaning the BurnersWiring Diagrams Shadowlight XL Parts Burner Module Parts Inlet Pressure To 7 inches Manifold Pressure Natural Gas InchesPropane Manifold Pressure Inches Inlet Pressure To 13 inchesBad Yes BadYes Pilot does not stay lit Bad GoodLight pilot Main Burner will not light with valve in on positionHarman Gold Warranty