Specifications
17
1
Door Hooks
Converting to High Altitude 3
Door Latches
Remove door by pulling latches out as shown and pulling the bottom of the door out from the unit about 3”. Then lift the door slightly up and off the hooks.
2
Remove log. Next, remove screw, washer and spacer from the center of the rear brick panel. Using one hand, gently push the side brick/relief door open slightly and using the other pull the top of the rear brick panel forward and remove it.
Remove air plate by lifting it up about 3 inches and then out of firebox. Be careful not to damage side brick panels
4
Remove the screws mounting the intake air deflector and lift it from the firebox. Next locate the screw holding the burner tube to the firebox floor and remove it. Now the burner orifice can be removed using a 1/2” deep well socket and replaced with orifice required for type of fuel being used. Refer to safety label for orifice size.
If this is a new unit, the Natural Gas Conversion Kit must be used when installing the Natural Gas High Altitude Kit.