24 Installation | Only For Qualified Installers | |
|
|
|
Thermostat
Part #
Burner Button
Connecting the
Optional Thermostat
If the optional thermostat is used, it must be plugged into the terminal strip located in the lower left front corner of the heater.
When installing a millivolt control system, use only a special low resistance thermostat. DO NOT USE A REGULAR HEATING THERMOSTAT.
Be sure that all electrical connections are clean, free from corrosion, and tight. Inspect connections periodically to confirm that no corrosion has built up over time.
When properly installed and maintained, a millivolt control system should give many years of
It is important to use the proper gauge wire for the length used.
RECOMMENDED WIRE GAUGES
Maximum | Wire |
Length | Gauge |
100’ | 14 |
60’ | 16 |
40’ | 18 |
25’ | 20 |
15’ | 22 |
Remote Control
The button on the remote control can be used to turn the burner on and off.
This remote uses an ultrasonic control method and does not need to be pointed directly at the fireplace.
A hand held sending unit, receiving unit, mounting bracket and all wiring are included when you order the remote control.
Installation instructions are packed with remote kit.
Part #