22 Installation | Only For Qualified Installers | |
|
|
|
9 | 11 | |
Connect the gas pipe to the stove unit. If the pipe adapter was removed from the stove, replace all components back onto the stove in the reverse order from which they were removed.
Place rock wool on burner as shown above. The wool should be placed loosely and lightly. This wool forms the glowing ember bed and will look different depending on placement. Reinstall the glass door assembly and close the latches.
Do not stike glass or close door with excessive force. Breakage of glass and/or damage to door may result.
10 | 12 |
Place log set in firebox. Center the logs right to left and push back against the log stop.
The power cord comes out the right side of the unit from the factory. The power cord may be changed to the left side before installing the face. Start by bringing the plug end of the cord back through the side of the firebox, and lifting the strain relieved cord section up from body notches. Keeping the cord along the front of the stove bottom run the plug end under the label holding brackets and out the same area on the other side of the stove body. Press the strain relieved cord section into the notches on the left side of the stove body and secure the cord to the front bottom section of the stove using wire ties.
Back out the 4 face clamping bolts far enough to install the face. Slide the face onto the firebox assembly until the slots are just fully under the heads of the bolts and are all even, then tighten the 4 bolts as shown above. Check to see if the back of the stove face meets with the fireplace opening as neatly as possible, some adjustment may be necessary. If the face is slid too far back under the bolts the glass door will not be able to be removed without taking the face off first. Some applications may be required to be installed that way.