26Maintenance
Air Out
Air In
The flow of convection air must not be obstructed.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. “Verify proper operation after servicing.”
“Attention: Au moment de l’entretien des commandes, eriquetez tous les fils avant le debranchement. Des erreurs de c>blage peuvent entraTun fonctionnement inadequar et dangereux.”
The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean.
“Ifthevent/airintakesystemisdisassembled for any reason, reinstall per the instructions provided for the initial installation.”
Only use Authorized Harman Service or Repair parts when working on your Shadowlight XL gas fireplace insert.
Air Flow
To prevent damage to the heater, it is essential that air flows freely into the bottom grill and out of the top grill. Do not place objects in front of the grills.
Cleaning the Burners
To clean the burners, the face, glass front, and log set must be removed. Remove the burner assembly as described on page 15.
With the burner removed, inspect all of the holes to make sure they are unobstructed. Use a small drill or wire to clean any obstructed holes. Remove any rust or other buildup that may have accumulated.
Replace burner in reverse order.
Replacing The Blower
To replace the blower the stove must be removed from the fireplace.
1.Shut off power and gas to stove
2.Remove face assembly
3.Remove glass door
4.Remove log, Rear brick panel and firebox rear cover plate.
5.Loosen nut on “J” bolt under the cover and remove “J” bolt
6.Disconnect power cord and gas line
7.Protect hearth
8.Remove stove from fireplace being careful not to damage flex pipes while removing adapter from the top of the stove.
9.Remove rear cover from stove body
10.Disconnect wires from blower motor
11.Remove screws mounting blower to blower mount
12.Replace blower.
13.Assemble in reverse order.