Now look at the factory preprogrammed times and temperatures shown at right. If this program
will suit your needs, simply press PRGMRUN to begin running the factory preset program.
If you want to change the preprogrammed times and temperatures, follow these steps.
1.Determine the heating and cooling tempera- tures you want to use. You may select up to fourheatingtemperatures(HEAT A,HEAT B, HEAT C, and HEAT D), and up to four cooling temperatures (COOL A, COOL B, COOL C, and COOL D). Use the table on the following page to write down the temperatures you have selected.
2.Determine the time periods during which you will program the temperatures you have just selected. You must program four peri- ods for each day (periods 1, 2, 3, and 4).
| FACTORY PREPROGRAMMING CHART |
| |||
Heating Program for | Cooling Program for | ||||
ALL days of the Week: | ALL Days of the Week: | ||||
PERIOD | TIME | TEMP | PERIOD | TIME | TEMP |
1 | 5:00 AM | 70 | 1 | 5:00 AM | 78 |
2 | 9:00 AM | 70 | 2 | 9:00 AM | 82 |
3 | 4:00 PM | 70 | 3 | 4:00 PM | 78 |
4 | 10:00 PM | 64 | 4 | 10:00 PM | 78 |
However, you may use the same heating and cooling temperatures for consecutive time periods. Also keep in mind that, for any given day, you can only program one set of times for both heating and cooling (for ex- ample, if you select 5:00 AM to begin heat- ing period 1 on Monday, then your cooling period 1 for Monday will also begin at 5:00 AM). However, you may choose different time periods for each day separately (for example, heating/cooling period 1 on Mon- day may begin at 5:00 AM, but heating/ cooling period 1 on Saturday may begin at
18