Heat & Glo LifeStyle 6000TRI-SP, 6000TRI-IPI manual Flue Restrictor Instructions, Vertical Venting

Page 15

STRAIGHT UP

VERTICAL VENTING

V (FT.)

40' MAX. (12.4 M)

NOTE: On vertical venting configurations over 10 feet install the flue restrictor (385-128) included in the manual bag assembly. See flue restrictor instructions.

Figure 6.

Straight Up Vertical Venting

Flue Restrictor Instructions

1.Remove Exhaust Shield using a 1/4” nut driver by removing the four screws securing it in place (see Figure 7).

EXHAUST

SHIELD

FLUE

RESTRICTOR

Figure 7

2.Break the Flue Restrictor into two pieces. Do this by bending the part back and forth until it breaks (see Figure 8).

BREAK

HERE

Figure 8. Flue Restrictor

Heat & Glo • 6000TRI-IPI, 6000TRI-SP • 385-901 Rev. F • 5/05

15

Image 15

Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents 6000TRI-IPI, 6000TRI-SP Log set assembly6000TRI-SP, 6000TRI-IPI Service Parts List / Liste des pièces de rechange6000TRI-IPI Intermittent Pilot Ignition Valve Assembly6000TRI-SP Standing Pilot Ignition Valve AssemblyCertification Installation CodesHigh Altitude Installations Appliance CertificationPre-install Preparation Introducing the Heat & Glo Gas FireplacesANY Such Action MAY Possibly Cause a Fire Hazard Diagram of the 6000TRI-IPI, 6000TRI-SP Constructing the Fireplace Chase Locating the FireplaceClearance Requirements Framing the Fireplace Framing DimensionsDVP90ST Identifying Vent Components Installing the Vent SystemVent System Approvals Tems or Components MAY be UsedFlue Restrictor Instructions Vertical VentingMAX .4 M Straight Up Vertical Venting Chart Venting with One 90 Elbow Venting with ONE 1 90 ElbowVenting with Two 90 Elbows Venting with TWO 2 90 o ElbowsVenting with three 90 elbows Venting with Three 3 90 Elbows+ V 1 FT + H 1 FT Installing Vent Components To Install the Heat Shield Install Support BracketsContinue Adding Vent Components 12 Hole and Vent Pipe Attic Firestop Vent TerminationVent Termination Minimum Clearances Positioning, Leveling, Securing the Fireplace Proper PositioningLeveling and Securing of a Fireplace Intermittent Pilot Ignition IPI System Installing the Optional Heat-Zone KitVice Must be Wired Directly to the FIRE- Place Junction BOX Gas Control SystemsGas Supply Line Gas Pressure RequirementsPressure Natural Gas Propane Intermittent Pilot Ignition IPI Wiring Diagram Wiring the Fireplace Sealant Material Hearth Extensions FinishingInstalling Trim, Logs, and Ember Material Double-check for faulty components Air Shutter SettingBefore Lighting the Fireplace Important Turn OFF the GAS Before Servicing Your Fireplace After the InstallationFireplace Maintenance Lighting the Fireplace