Desa (V)CB36N(E) Product Features, Pre-Installation Preparation, Location and space requirements

Page 5

Product Features

These are a few facts that can help you understand and enjoy your vented decorative fireplace:

•The (V)CB36N(E) and (V)CB36P(E) series of vented decorative fireplaces may be recessed into an exterior chase, an interior flush wall enclosure or a framed-in corner installation.

•Models (V)CB36N and (V)CB36P are equipped with a millivolt gas control system that does not require electricity to operate. A piezo ignitor is provided to light the pilot without using matches or lighters.

•Models (V)CB36N(E) and (V)CB36P(E) are equipped with an electronic ignition system that requires 120 VAC to operate. An electrode ignitor automatically lights the pilot flame when the fireplace is turned on.

•These fireplaces can accept any approved 4"

B-Type venting system and must be terminated vertically through the roof using a listed type vent cap only. See venting instructions starting on page 8 for proper venting requirements.

•These vented fireplaces require indoor air for combustion and must be installed in a room of sufficient size to provide adequate fresh air for safe and proper operation. The room intended for installation must be of sufficient size to meet the requirements for an unconfined space as defined in the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Section 5.3, Air for Combustion and Ventilation. If sufficient air for combustion is not available a makeup air kit model AK4 may be required to provide outside air to this appliance. Check your local codes as to specific requirements for make up air.

•This fireplace may be installed in any room of the house provided all local codes and these installation instructions are followed.

When deciding the location of your fireplace, follow these rules:

•Do not connect this fireplace to a chimney flue servicing a separate solid fuel burning fireplace or appliance.

•Do to high temperatures, do not locate this fireplace in high traffic areas, windy or drafty areas, or near furniture or draperies.

•Proper clearances must be maintained.

•If your fireplace is to be installed directly on carpeting, vinyl, tile or any combustible mate- rial other than wood, it must be installed on a metal or wood panel extending the full width and depth of the fireplace (see Figure 3).

•Only trim kits supplied by DESA shall be used in the installation of this fireplace, see Acces- sories, page 34.

•Do not install aftermarket vent dampers.

Manual or automatic vent dampers are not ap- proved for use with this appliance.

•Your fireplace is designed to be used in zero clearance installations. Wall or framing material can be placed directly against any exterior sur- face on the back, sides or top of your fireplace, except when clearances are required from flue vent pipe, see Clearances on page 6.

•If recessed into a wall, you can avoid extra framing by positioning your fireplace against an already existing framing member.

Flush with a wall

Corner

Through exterior wall

Installation

enclosed in a chase

 

Pre-Installation

Preparation

Location and space requirements

Determine the safest and most efficient location for your DESA direct-vent fireplace. Make sure that rafters and wall studs are not in the way of the venting system. Choose a location where the heat output is not affected by drafts, air conditioning ducts, windows or doors. Figure 2 shows some common locations. Be aware of all restrictions and precautions before deciding the exact location for your fireplace and termination cap.

Figure 2 - Common Fireplace Locations

25"

(63.5 cm)

36"

(91.4 cm)

36"

(91.4 cm)

Figure 3 - Fireplace Bottom Dimensions

117437-01Bwww.desatech.com

Page 4 Page 6
Image 5
Page 4 Page 6
Contents VCB36NE and VCB36PE ModelsTable of Contents Safety information Local Codes Product IdentificationLocation and space requirements Product FeaturesPre-Installation Preparation Framing and Finishing Packaging and RemovalClearances However, 0 clearance is also Mantel ClearancesVenting Installation Installation PrecautionsVenting Installation Electrical Supply Connection Checking for Proper VentingHigh Altitude Installation Installing Optional ControlsInstalling Optional Wall Mount Switch GWMS2 Installing Remote ReceiverInstalling and Activating the Remote Receiver Installing Optional ControlsWiring Diagrams Millivolt Wiring DiagramInstalling Gas Piping to Fireplace Location Fireplace InstallationInstallation Items Needed Check GAS TypeNatural From Connecting Fireplace to GAS SupplyChecking GAS Connections Test Pressures Equal To or Less Than Psig 3.5 kPa Pressure Testing Fireplace Gas ConnectionsLouver Panels and Glass Door Glass Panel Frame Rail Removing Louver PanelsRemoving/Replacing Glass Door Spring Clips Applying Ember Material Installing Logs and Glowing EmbersOperating Fireplace Manual Ignition System For your safety Read before lightingLighting Instructions To Turn OFF GAS To ApplianceElectronic Ignition System Lighting Instructions Manual Lighting ProcedureOptional Wireless Remote Operation On/Off Series Model HRC100 Optional GWMS2 ON/OFF Wall Mounted SwitchOptional Hand-Held Air Adjustment Setting Pilot AssemblyInspecting Burners Burner Flame PatternsPilot and Burners Cleaning MaintenanceGlass Door Logs SpecificationsVenting System VCB36NEObserved Problem Possible Cause Remedy TroubleshootingLong enough See Lighting Instructions Observed Problem Possible Cause RemedyNo gas supply, or shutoff Statement above TroubleshootingIllustrated Parts Breakdown Parts List Illustrated Parts Breakdown Instructions Service Hints Replacement PartsTechnical Services AccessoriesGWMS2 Not Shown Remote Control KIT WRC SeriesWall Mounted ON/OFF Switch Limited Warranty Vent Fireplace Warranty InformationKeep this Warranty

(V)CB36P(E), (V)CB36N(E) specifications

The Desa (V)CB36N(E) and (V)CB36P(E) represent a significant advancement in heating technology, offering efficient and reliable heating solutions for diverse residential needs. Both models showcase an amalgamation of modern design, energy efficiency, and user-friendly features, making them ideal for contemporary living spaces.

One of the standout features of the Desa (V)CB36N(E) and (V)CB36P(E) is their exceptional heating capacity. Designed to deliver a consistent and comfortable temperature, these units can effectively heat areas of various sizes, ensuring that even larger living rooms or open spaces maintain a cozy ambiance. The (V)CB36N(E) is particularly noted for its natural gas compatibility, while the (V)CB36P(E) offers flexibility with propane options, catering to varying user preferences and available fuel sources.

Both models are equipped with advanced technologies that enhance their performance and efficiency. The use of high-efficiency burners significantly boosts their output while minimizing fuel consumption. This strategic design not only prolongs the lifespan of the units but also contributes to reduced greenhouse gas emissions, aligning with the growing demand for environmentally friendly heating solutions.

In terms of safety, Desa places a strong emphasis on user protection. Each unit is equipped with a robust safety shut-off system that activates when certain operational parameters are not met, ensuring peace of mind for users. Additionally, the inclusion of a protective mesh screen on both models helps prevent accidental burns, particularly important in households with children or pets.

Aesthetically, the Desa (V)CB36N(E) and (V)CB36P(E) blend seamlessly into any interior décor. With customizable design options and finishes, users can select models that best fit their home’s theme, whether it be contemporary, rustic, or traditional. This flexibility helps homeowners enhance their living spaces while also reaping the functional benefits of these heating units.

Furthermore, the intuitive controls allow for effortless operation, making temperature adjustments quick and convenient. With remote control capabilities available in some models, users can manage their heating systems from the comfort of their seating areas.

In conclusion, the Desa (V)CB36N(E) and (V)CB36P(E) offer a perfect combination of performance, safety, and style. With their innovative technologies and user-friendly features, these heating solutions stand out in the market as reliable choices for those seeking efficient home heating options.
Top Page Image Contents