OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
8. Plug in blower power cord. |
a. If your fireplace system is installed |
as a freestanding unit with an ac- |
cessory mantel, determine whether |
the power cord will exit the left side |
or the right side of the firebox. In- |
stall one plastic bushing provided |
into the 1 1/2" hole in the outer cas- |
ing through which the power cord |
will exit. Install the second plastic |
bushing provided into the floor sup- |
port bracket if exiting through the |
9.Check to make sure that the power cord is completely clear of the blower wheel and that there are no other foreign ob- jects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclock- wise before continuing.
WARNING: Never touch the blower wheel while in operation.
10.Peel off the backing paper and stick the supplied wiring diagram decal on the firebox bottom approximately 3" to the right of the blower speed control bracket (Figure 32).
WARNING: Failure to position the parts in accordance with sup- plied diagrams or failure to use only parts specifically approved with this heater may result in dam- age or personal injury.
11.Connect or reconnect gas supply to fire- place per Connecting Fireplace to Gas Supply on page 19 of this manual.
WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.
right side (see Figure 32). Route |
power cord through (both) plastic |
bushing(s) and plug the power cord |
into a properly grounded |
wall receptacle near the firebox. |
b. If your fireplace system installation |
is recessed and/or |
Firebox Bottom | Firebox Back |
Firebox Flange
ThermalBlower Switch
qualified installer must make all elec- |
trical connections for the outlet kit |
included with the fireplace. |
Lower Rear
Wall of
Firebox
Wrapper
Lower Louver
Blower Panel
Screws
Exhaust Port
Top
Mounting
Tab
Figure 29 - Mounting Blower to Firebox
Thermal
Switch
Bracket
Thermal Switch
Figure 30 - Locating Thermal Switch Against Back of Firebox
Speed
Control
Control
Knob
Control Shaft
Locknut
Figure 31 - Attaching Speed Control to
Firebox
Wiring
Diagram
Blower Speed | Plastic Bushing |
Control Bracket |
Figure 32 - Installing Plastic Bushing and
Wiring Diagram Sticker
Side View
Continued
106394 | 17 |