OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
Attaching Magnetic Decorative
Brass Strips
(Optional Installation)
Before attaching strips to fireplace, remove plastic film from brass pieces. After install- ing door, attach these strips to the top and bottom of glass door frame.
INSTALLING OPTIONAL BRICK LINER D8037A
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Accessories, pages 36 and 37.
CAUTION: Always handle brick panelswithtwohands.Donotforce brick panels into place. Excessive force will break brick panels.
1.Remove glass door. See Removing/Re- placing Glass Door, page 22.
2.If installing brick liner in new fireplace, go to step 3. If installing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
3.Install rear brick panel first. Rest bot- tom edge of panel on back edge of grate (see Figure 49).
4.Loosely secure retainer brackets to grate. Brackets are adjustable left to right to allow proper placement of panel. These will hold rear panel in place while installing side panels.
5.Install left side brick panel by sliding it between the grate and the side of the firebox (see Figure 50).
6.Slide the left retainer bracket against the left side brick panel. Tighten the bracket screw. This secures both the left side and rear brick panels.
7.Install the right brick panel using the same method described in step 5.
8.Slide the right retainer bracket against the right side brick panel. Tighten the bracket screw. This secures both the right side and rear brick panels.
9.Follow instructions on page 24 to install logs, lava rock, and ember material.
10.Replace glass door (see page 22).
Rear Brick
Panel
Retaining
Brackets
Figure 49 - Installing Rear Brick Panel and Retainer Brackets
Left Side
Brick Panel
Retainer
Brackets
Figure 50 - Installing Left Side Brick Panel | Continued |
106394 | 23 |