Product
Identification
Log Set | Rear | |
Burner | ||
|
Optional | Front | |
Burner | ||
Remote | ||
Base | ||
Control | ||
Assembly | ||
| ||
Figure 1 - Log Base Assembly | ||
| (VSGF36NRB Shown) |
| Top Outer |
Top Louver | Casing |
| |
Assembly |
|
Fireplace |
|
Hood |
|
Screen
Assembly
Bottom Louver
Assembly
Figure 2 - Fireplace (VSGF36NRB Shown)
Unpacking
CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important warranty and safety information.
1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located on top of fireplace in a carton.
2.Locate one screw above top left corner of the fireplace screen. Remove and discard screw. Lift fireplace screen up and pull out to remove.
3.Remove protective packaging applied to logs, log base assembly and fireplace.
4.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought fireplace.
Product Features
Operation
This
Safety Device
This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/ pilot is a required feature for
Piezo Ignition System
This fireplace has a piezo ignitor. This system requires no matches, batteries or other sources to light fireplace.
OPTIONAL REMOTE CONTROL accessory
There are four optional remote controls (not included) that can be purchased separately for this log heater:
•wall switch
•wall thermostat
•
•
See Accessories, page 31.