Vermont Casting DVT44 Lighting & Operating Instructions, Lighting Instructions

Page 30
If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury and loss of life.

Chateau™

Lighting & Operating Instructions

For Fireplaces equipped with American Flame Automatic Control System (IN or IP) Warning:

For Your Safety, Read the Following Warnings

before Lighting the Appliance

A.This fireplace is equipped with an ignition device which automatically lights the pilot and main burner. The pilot and burner light automatically with the hand held remote control only. DO NOT try to light the pilot by hand. Before lighting this appliance, follow these instructions exactly.

B.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to

the floor because some gas is heavier than the air and will settle on the floor.

What to do if you smell gas

Do not try to light any appliance.

Do not operate any electrical switch.

Do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppliers instructions.

If you cannot contact your gas supplier call the Fire Department

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been under water.

Lighting Instructions

1.STOP! Read the safety information above before continuing.

2.Turn off all electrical power to the appliance.

Spark to Pilot Pilot Assembly

3.This appliance is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.

“S” Connection Connect to Module

4.Turn the wireless remote OFF.

5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP. Follow instruction B in the safety warnings above. If you do not smell gas, go on to the next step.

6.Turn ON all electrical power to the appliance.

7.Turn wireless remote ON.

9.If the appliance will not operate, follow the instructions TURNING OFF THE GAS TO THE APPLIANCE, and call your service technician or gas supplier.

Black Plastic Cap

Pilot Gas

 

Connection Side or Back

“I” Connection

Pilot

 

 

Connect to

Adjustment

Motor Wires

Module

Screw

 

 

 

 

Motor Drive

 

Minimum Rate

 

Screw

Pilot Internal Solenoid

Main Valve Internal Solenoid

Connection

Connection

Orange & White Wires

Green & White Wires

Turning Off the Gas to the Appliance

1.Turn the wireless remote to the OFF position.

2.Turn OFF all electrical power to the fireplace if service is required.

3.Turn the shut-off valve on the gas supply line to the OFF position.

1/2” NPT X 1/2” Flare

Shut-off Valve

 

1/2” Gas Tight or

 

Tinned Copper

1/2” Gas Supply

(from valve)

(Not provided)

30

20011956

Image 30
Contents INSTALLER/CONSUMER Safety Information What to do if YOU Smell GASTable of Contents Installation & Operating Instructions Please Review the Following CarefullyFireplace Dimensions DVT38 Locating Your Fireplace Clearance to CombustiblesMantels Hearth Framing and FinishingFinal Finishing Gas Inlet and Manifold Pressures Gas Line InstallationGas Specifications High ElevationsControl System Installation Electrical Junction BoxControl System Special Feature for Cold Climates Connect 120V AC electrical supplyGeneral Venting Location of Vent TerminationCanadian Installations1 US Installations2 General Venting Information Termination LocationQuick Reference for Fresh Air Restrictor Plate / Flue Baffle ApplicationDVT38N DVT38P DVT44N DVT44P General Information Assembling Vent Pipes SK8 Venting Pipes Canadian InstallationsUSA Installations Horizontal TerminationSidewall Applications Use of the Restrictor Plates Horizontal Venting ApplicationsSidewall Installation StepAlways install horizontal venting on a level plane Vertical height requirementFresh Air Restrictor Plate Vertical Through-the-Roof Installation Typical offset applicationMin 610mm Chimney Components Component Description Model NumberRestrictor Plate Installation Glass Frame Assembly RemovalGlass Cleaning Operating InstructionsCeramic Refractory Installation Appliance Kit Model DescriptionLog, Lava Rock and Ember Placement DVT38 LogsPosition the Log Grate Burner. Remove the two Mandatory for proper carry over of flame into the burner tubePosition the Log Rear Left Position the Log Front Middle Right DVT38 logset complete Flame Characteristics Correct pilot flame appearanceTrim Installation Trim frame in placeLighting & Operating Instructions Lighting InstructionsTurning Off the Gas to the Appliance Troubleshooting Igniter operationTroubleshooting American Flame Gas Control System Conversion Precautions Conversion ProcedureFuel Conversion Instructions Converting the Gas Control Valve Check Manifold PressureInjector Orifice Size Matrix Air Shutter SettingsPilot Flame Adjustment Valve Minimum Rate ScrewMaintenance Cleaning the Control SystemBurner and Burner Compartment DVT38, DVT44 DVT38 DVT44 Colonial Red Limestone HerringboneFuel Conversion Kits Accessories Back-up Battery KitCeramic Refractory Kits Chateau Chateau Limited Lifetime Warranty Product Covered by this WarrantyEfficiency Ratings Model EnerGuide Ratings Fireplace Efficiency %