Vermont Casting DVT44 installation instructions General Venting, Location of Vent Termination

Chateau™

White or Green

Green or White

White or Orange

Orange or White

DC Motor		Pilot		Main
		AF-4000		Module
	Main			Learn
				Button
Black			Power	Orange
			Module	Red
Red				Brown
				Black

Pulse/Continuous

Button

To Pilot Ignitor

To Pilot

Flame Sensor

	I
	S	Optional Remote
		Battery Back-Up Pack
		Remote/Off
		Switch
		Continuous
		Pilot ON/OFF
		Switch
		Extension
		Wire Harness
	Black	Gnd	Red	Black
Brown	(SWI) (Leave
Brown	(SWI) Disconnected)

Red

Black

FP1795

AC Adaptor

Optional Extension Harness

Fig. 11 DVT38/44 wiring diagram.

General Venting

Your fireplace is approved to be vented either through the side wall, or vertical through the roof.

•Only CFM Corporation venting components spe- cifically approved and labelled for this fireplace may be used.

•Venting terminals shall not be recessed into a wall or siding.

•Horizontal venting must be installed on a level plane without an inclining or declining slope.

There must not be any obstruction such as bushes, gar- den sheds, fences, decks or utility buildings within 24” (610 mm) from the front of the termination hood.

Do not locate termination hood where excessive snow or ice build up may occur. Be sure to check vent termi- nation area after snow falls, and clear to prevent ac- cidental blockage of venting system. When using snow blowers, make sure snow is not directed towards vent termination area.

Location of Vent Termination

It is imperative the vent termination be located observ- ing the minimum clearances as shown on following page.

10 20011956