Operating Instructions, Glass Information

Chateau™

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•A replacement glass frame assembly (complete with gasket) is available through your CFM Corporation dealer and should only be installed by a licensed qualiﬁed service person.

��

Glass Frame Assembly Removal

1.Turn the ﬁreplace OFF (including the pilot).

2.If the unit has been operating allow time for the components to cool.

3.Using a Phillips screwdriver, unfasten two (2) screws located at the top of the glass frame. (Fig. 34)

4.Tilt the glass frame at the top away from the unit. Lift it carefully off the bottom door track and set on padded surface.

Glass Cleaning

It is necessary to periodically clean the glass. During start-up, condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to the glass surface.

Also initial paint curing may deposit a slight ﬁlm on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (gas ﬁreplace glass cleaner is recommended) within the ﬁrst few weeks of operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

20011956

Clean the glass after the ﬁrst two weeks of operation.

Phillips

Screws

FP1558a

Fig. 34 Remove Phillips screws, tilt frame forward and lift off bottom door track. (Shown without logs for clarity.)

Restrictor Plate Installation

Refer to Pages 12, 13 & 16 for your venting conﬁgura- tion and combination of restrictor plate requirement and fresh air restrictor plate adjustment.

Restrictor Plate Installation

Using the two (2) screws provided along with the restic- tor plate shipped with the logset, fasten the restrictor plate to the ﬁrebox top through the front of the unit. (Fig. 35)

Fresh Air Restrictor Plate Adjustment

1. Remove the glass.

2. Remove the logs, andirons and fettle.

3. Remove one side refractory (right or left) and re- move the rear upper and lower refractory in reverse order of installation. (Refer to “Ceramic Refractory Installation” section.)

4. Remove the rear log bracket by removing three (3) screws. On some models you may be able to loosen the screws and slide bracket to the left and out. (Fig. 36)

5. Adjust the fresh air restrictor plate setting. (Fig. 37) Simultaneously install the plate and the log bracket using the three (3) screws loosened or removed ear- lier. The adjustment is made by matching the proper setting on the plate with the three (3) holes on the

ﬁrebox back.