Vermont Casting DVT44 installation instructions Log, Lava Rock and Ember Placement, DVT38 Logs

Page 23

Chateau™

3.Start with either the right side refractory or left side refractory. Hold the refractory at an angle. Slide and seat the bottom edge toward the bottom of the firebox. Tilt it carefully toward the side until the piece is in place. Slide the refractory forward until it comes in contact with the front flange on the firebox.

4.Holding the rear refractory lower straight up, rotate it back behind the side refractory and set it on the small return bend of the rear log bracket toward the back of the firebox. Ensure the mortar lines in the refractory match the side refractory already installed.

5.Rotate back and set on the rear log bracket toward the back of the firebox.

6.The rear refractory upper has a notch in the top side. Holding the refractory at an angle, slide the refrac- tory behind the side refractory installed.

7.While holding the rear refractory upper in place, fol- low Step 3 and install the remaining side refractory.

8.Adjust all refractory pieces so mortar lines are aligned. Replace heat shield removed in Step 2. Make sure the angle on the heat shield goes back. This will secure the side refractory in place.

9.Reinstall the burner tube and fettle.

Log, Lava Rock and Ember Placement

Unpack the logs and log burner overlay from packag- ing. Remove each log from its wrapping material.

Tools required: Robertson or Phillips screwdriver

The logs are fragile and should be handled with care. Keep the packaging materials out of the reach of children and dispose of the material in a safe manner.

IMPORTANT: Review these instructions and famil- iarize yourself with each log before beginning log placement. Find the notches, pins and indentations on each log. Follow the instructions closely, using the Log ID (Fig. 40 or 41) and the illustrations to as- sist in correctly placing each log.

DVT38 Logs

Log Front Middle Left

Log Grate Burner

Log Rear Right

Log Burner Overlay

Log Front Middle Right

Log Rear Left

Log Front Right

Log Grate Right

Log Front Left

Log Front Upper Right

Log Grate Left

LG412

Fig. 40 DVT38 log identification.

20011956

23

Image 23
Contents What to do if YOU Smell GAS INSTALLER/CONSUMER Safety InformationTable of Contents Please Review the Following Carefully Installation & Operating InstructionsFireplace Dimensions DVT38 Mantels Locating Your FireplaceClearance to Combustibles Final Finishing HearthFraming and Finishing High Elevations Gas Line InstallationGas Specifications Gas Inlet and Manifold PressuresControl System Control System InstallationElectrical Junction Box Connect 120V AC electrical supply Special Feature for Cold ClimatesLocation of Vent Termination General VentingGeneral Venting Information Termination Location Canadian Installations1 US Installations2DVT38N DVT38P DVT44N DVT44P Quick Reference for Fresh Air Restrictor Plate / Flue BaffleApplication Horizontal Termination Canadian InstallationsUSA Installations General Information Assembling Vent Pipes SK8 Venting PipesUse of the Restrictor Plates Horizontal Venting Applications Sidewall ApplicationsStep Sidewall InstallationVertical height requirement Always install horizontal venting on a level planeFresh Air Restrictor Plate Typical offset application Vertical Through-the-Roof InstallationMin 610mm Component Description Model Number Chimney ComponentsOperating Instructions Glass Frame Assembly RemovalGlass Cleaning Restrictor Plate InstallationAppliance Kit Model Description Ceramic Refractory InstallationDVT38 Logs Log, Lava Rock and Ember PlacementMandatory for proper carry over of flame into the burner tube Position the Log Grate Burner. Remove the twoPosition the Log Rear Left Position the Log Front Middle Right DVT38 logset complete Correct pilot flame appearance Flame CharacteristicsTrim frame in place Trim InstallationTurning Off the Gas to the Appliance Lighting & Operating InstructionsLighting Instructions Igniter operation TroubleshootingTroubleshooting American Flame Gas Control System Fuel Conversion Instructions Conversion PrecautionsConversion Procedure Check Manifold Pressure Converting the Gas Control ValveValve Minimum Rate Screw Air Shutter SettingsPilot Flame Adjustment Injector Orifice Size MatrixBurner and Burner Compartment MaintenanceCleaning the Control System DVT38, DVT44 Colonial Red Limestone Herringbone DVT38 DVT44Fuel Conversion Kits Ceramic Refractory Kits AccessoriesBack-up Battery Kit Chateau Chateau Product Covered by this Warranty Limited Lifetime WarrantyModel EnerGuide Ratings Fireplace Efficiency % Efficiency Ratings