Chateau™
DVT44 Logs
Log Rear Right | Log Front Middle Right |
|
Log Grate Burner
Log Burner Overlay
Log Rear Left | Log Front Right |
|
Log Front Upper Right
Log Grate Right | Log Front Left |
Log Grate Left | Log Front Middle Left | Log Rear Upper Middle |
|
|
LG413
Fig. 41 DVT44 log identification.
1.Position the Log Grate Burner. Remove the two
(2) screws that attach the fettle to the burner. Place the log grate burner between the notch on the front of the burner housing behind the burner tube. (Fig. 42) Hold the log in place and set the fettle back in position. When the fettle is in position, it must hook onto the log. Refasten fettle in place. NOTE: The log should look as if it has fallen off the grate.
2.Position the Log Burner Overlay. The overlay is very fragile and must be handled with extra care. Hold the overlay with the flat surface facing down.
Figure 42
Log
Burner
Overlay
LG401
Log Grate Burner
The notch for the pilot on the overlay should be in the right rear corner. Set the overlay on top of the burner housing toward the back. The overlay must line up with the sides and back of the burner. The overlay rests behind the log grate burner. Make sure the pilot hood lines up with the notch on the overlay. (Fig. 42)
3.Position the Andirons. Set the andirons in place by hooking the tabs on the back of the andiron over the outermost web of the fettle. (Figs. 48 & 49)
4.Place the Volcanic Rock. Place the volcanic rocks over the hearth refractories in front of the burner tube and around the burner assembly as desired.
(Figs. 48 & 49)
5.Place the Small Lava Rock. Place the small lava rock approximately 1¹⁄₂” (38 mm) wide behind the lip mounted to the burner housing. Place ember material lightly di- rectly behind the lava rock and the overlay.
(Figs. 48 & 49)
6.Place the Ember Material. Place the ember material in front and around the burner tube and behind the burner
tube in front of the burner hous- ing. Build up the ember material lightly over the burner tube into the burner housing to cover up the burner tube and the lip mounted to the front of the burner housing. (Figs. 48 & 49) NOTE: Placing platinum ember material is
mandatory for proper carry over of flame into the burner tube.
24 | 20011956 |