Vermont Casting DVT44 Injector Orifice Size Matrix, Air Shutter Settings, Valve Minimum Rate Screw

Chateau™

			Table 1	Injector Orifice Size Matrix
					Conversion to LP
					Burner Orifice				Input (BTU/hr)
Kit #	Model	Front	Part #		Middle	Part #	Rear	Part #	Minimum	Maximum
20011992	DVT38IP	#66	20009182		#59	20000664	#50	30000337	34,000	46,000
		(.033”)			(.041”)		(.070”)
20012367	DVT44IP	#63	20006251		#57	20004587	#49	20006252	45,000	60,000
		(.037”)			(.043”)		(.073”)

Table 2 Air Shutter Settings

Conversion to LP

	Burner Tube	Burner Housing
Model	Air Shutter Setting	Air Shutter Setting
DVT38IP	Fully open	n/a
DVT44IP	Fully open	Fully open

Table 3 Valve Minimum Rate Screw

Model	Size	Part #
DVT38IP	#31 (.120”)	20012364
DVT44IP	No Shank Screw	20012264

Pilot Flame Adjustment

Typically, the top 3/8” or 1/2” of the pilot flame sensor should be engulfed in the pilot flame. (Page 28, Fig. 50)

To adjust pilot burner:

1.Locate pilot adjustment screw on the valve next to the black plastic cap. Refer to Page 30.

2.Adjust pilot screw to provide proper sized flame. Only a small adjustment should be needed.

NOTE: Do not rotate screw excessively. Do not adjust any other screws on the valve.

20011956 35