Vermont Casting DVT44 installation instructions INSTALLER/CONSUMER Safety Information

Page 1

INSTALLER/CONSUMER SAFETY INFORMATION

PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE

WARNING!

IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

FOR YOUR SAFETY

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electric switch;

Do not use any phone in your building.

Immediately call your gas supplier from your neighbor’s phone. Follow the gas suppliers instructions.

If you cannot reach your gas supplier call the fire department.

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.

 

S

IG

 

E

N

D

 

 

Chateau™

Direct Vent Gas Fireplace

Model: DVT38, DVT44

Installation Instructions and

Homeowner’s Manual

C

E

R

T

IFIED

CERTIFIED

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

20011956 6/07 Rev. 3

Image 1
Contents What to do if YOU Smell GAS INSTALLER/CONSUMER Safety InformationTable of Contents Please Review the Following Carefully Installation & Operating InstructionsFireplace Dimensions DVT38 Clearance to Combustibles Locating Your FireplaceMantels Framing and Finishing HearthFinal Finishing Gas Specifications Gas Line InstallationGas Inlet and Manifold Pressures High ElevationsElectrical Junction Box Control System InstallationControl System Connect 120V AC electrical supply Special Feature for Cold ClimatesLocation of Vent Termination General VentingGeneral Venting Information Termination Location Canadian Installations1 US Installations2Application Quick Reference for Fresh Air Restrictor Plate / Flue BaffleDVT38N DVT38P DVT44N DVT44P USA Installations Canadian InstallationsGeneral Information Assembling Vent Pipes SK8 Venting Pipes Horizontal TerminationUse of the Restrictor Plates Horizontal Venting Applications Sidewall ApplicationsStep Sidewall InstallationVertical height requirement Always install horizontal venting on a level planeFresh Air Restrictor Plate Typical offset application Vertical Through-the-Roof InstallationMin 610mm Component Description Model Number Chimney ComponentsGlass Cleaning Glass Frame Assembly RemovalRestrictor Plate Installation Operating InstructionsAppliance Kit Model Description Ceramic Refractory InstallationDVT38 Logs Log, Lava Rock and Ember PlacementMandatory for proper carry over of flame into the burner tube Position the Log Grate Burner. Remove the twoPosition the Log Rear Left Position the Log Front Middle Right DVT38 logset complete Correct pilot flame appearance Flame CharacteristicsTrim frame in place Trim InstallationLighting Instructions Lighting & Operating InstructionsTurning Off the Gas to the Appliance Igniter operation TroubleshootingTroubleshooting American Flame Gas Control System Conversion Procedure Conversion PrecautionsFuel Conversion Instructions Check Manifold Pressure Converting the Gas Control ValvePilot Flame Adjustment Air Shutter SettingsInjector Orifice Size Matrix Valve Minimum Rate ScrewCleaning the Control System MaintenanceBurner and Burner Compartment DVT38, DVT44 Colonial Red Limestone Herringbone DVT38 DVT44Fuel Conversion Kits Back-up Battery Kit AccessoriesCeramic Refractory Kits Chateau Chateau Product Covered by this Warranty Limited Lifetime WarrantyModel EnerGuide Ratings Fireplace Efficiency % Efficiency Ratings