Maintenance And Service
BURNER REMOVAL:
The burner may need to be removed for a few reasons, including cleaning under the burner, converting the unit to a different gas type, or to replace the burner altogether. Proceed only when the unit has
completely cooled down.
1. Remove the fascia or louvers
2. Remove | the | glass as shown in the | |
MAINTENANCE AND SERVICE - GLASS DOOR | |||
REMOVAL. |
|
|
|
3. Remove | the | brick panels | as shown |
in SECONDARY | INSTALLATION | - OPTIONAL | |
CERAMIC BRICK PANEL INSTALLATION.
4. | Remove the left and right firebox |
|
| corners. |
|
5. | Remove the six (6) |
|
| the burner in place; three (3) along the |
|
| top and three (3) along the bottom. |
|
6. | Lift the burner straight up then out. | Figure 9. Removing Burner. |
To
FUEL CONVERSION:
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
Please read and understand these instructions before installing.
Warning: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper or complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.
Kit Parts List:
1 - Orifice (NG - #39 DMS or LP - #53 DMS)
1 - Pilot Injector (NG 0.62 mm; LP 0.35 mm)
1 - Installation instruction sheet
1 - Conversion label
Carefully inspect all parts supplied with this conversion kit. If any parts have been damaged or are missing, contact your dealer, distributor or courier company to have them replaced before starting this installation.
11