Enviro DV36 owner manual Installation of Kit, Hook Fan Tabs Over Grommets at Unit Back

Page 34

Secondary Installation

Figure 55. Hook Fan Tabs Over Grommets at Unit Back.

Installation of Kit:

1.Ensure the appliance is turned off and cool.

2.Remove the bottom louvers.

3.Place fan in lower area of unit behind the controls (see Figure 54).

4.Hook the two (2) slots on the fan box over the two (2) grommets on the back wall, refer to Figure 55.

5.Using two (2) T-20 screws, attach the fan control box to the ignitor control panel, refer to Figure 56. Before tightening the screws ensure that the thermal switch on top of the box firmly contacts the firebox bottom.

6.Plug the fan into the hard wired electrical box/outlet (refer to Figure 57) that was installed in the

“INITIAL INSTALLATION - INSTALLATION OF ELECTRICAL OUTLET FOR OPTIONAL FAN KIt“.

Figure 56. Install Fan Control Box.

Figure 57. Plug In Fan Kit.

34

Image 34

Contents For Your Safety R E C T V E N T F I R E P L a C ESafety Precautions GeneralTable of Contents Vented GAS Fireplace Heater DV36 NG/LPG Codes And ApprovalsThis Enviro DV36 Fireplace Specifications Installation OptionsFor Your Safety Read Before Operating InstructionsBlue, the fireplace is getting too much To Turn GAS Fireplace OFF Component Sound & ReasonMaintenance And Service Never Operate Fireplace with the glass Removed Bottom latches for glassKit Parts List Completely cooled downConversion Kit Installation Removing valve ScrewRing on valve screw Initial Installation Qualified Installers onlyDo not interfere with the structural integrity of the walls Mantel Clearances Vent Termination Restrictions Installation Instructions KIT ComponentsInstallation of Fireplace Horizontal Vent Kit Manufacturer Trade Name Nominal Sizes4DSC Two 2 piece wall Vent restrictor is located in the center Being Attached to Wood Assemble Vertical Vent TerminationRoof Pitch Minimum Height H Feet Meters Use of Wall Straps Installation of Electrical Wiring for the Optional FAN KIT GAS Line Connection To Test Valve PressuresSecondary Installation Empty firebox with grate and locator pinsThird Stage Log Set Installation Never operate the fireplace with the glass door removed Complete log set-up with embersTurn off the gas control knob and allow the unit to cool Back Panel In PlaceKit Contents Installation of Kit Hook Fan Tabs Over Grommets at Unit BackTrouble Shooting Problem Possible Cause SolutionParts List Reference Part Description Part NumberParts List Options Parts Diagram To the Dealer WarrantyTo the Distributor Installation Data Sheet