Regency U39-LP General Safety Information, Installation Checklist, Clearances to Combustibles

Page 6

INSTALLATION

into a manufactured home the unit must be bolted down to the floor.

4)This appliance is Listed for bedroom instal- lations when used with a Listed Millivolt Thermostat. Some areas may have further requirements, check local codes before installation.

5)This appliance is Listed for Alcove installa- tions, maintain minimum Alcove clearances as follows, minimum width of 48" (1219mm), a maximum depth of 36" (914mm), and minimum ceiling height of 64"(1626mm).

6)We recommend that you plan your installa- tion on paper using exact measurements for clearances and floor protection before actually installing this appliance. Have a qualified building inspector review your plans before installation.

GENERAL SAFETY INFORMATION

1)The appliance installation must conform with local Canadian Electrical Code.

2)The appliance when installed, must be elec- trically grounded in accordance with local codes, or in the absence of local codes with the current National Electrical Code, ANSI/ NFPA 70 or CSA C22.1 Canadian Electrical Code.

3)The appliance should be inspected for shipping damage before use andserviced annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpet- ing, bedding material, etc. It is imperative that control compartments, and circulating air passageways of the appliance be kept clean and free from excessive lint from carpeting.

4)See general construction and assembly instructions. The appliance and vent should be enclosed when installed in or passing through a living area, where children may come in contact with it.

5)This appliance must be connected to the specified vent and termination cap to the outside of the building envelope. Never vent to another room or inside a building. Make sure that the vent is fitted as per the instruc- tions starting on page 7.

6)Inspect the venting system annually for blockage and any signs of deterioration.

7)Venting terminals shall not be recessed into a wall or siding.

8)Any safety glass removed for servicing must be replaced prior to operating the appliance.

9)To prevent injury, do not allow anyone who is unfamiliar with the operation to use the fireplace.

Emissions from burning wood or gas could contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

INSTALLATION

CHECKLIST

1)Check Clearances to Combustibles (pages 6 and 7), location of unit (page 7) and venting requirements (pages 7 to 9).

2)Install Louvers, page 7.

3)Install venting, either with the DV Stove Horizontal Vent Kit (page 10) or the Dura- Vent Termination kits (page 12). Set Vent Restrictors, page 9. If converting a Class- A Metal Chimney or Masonry Chimney to a Direct Vent system, see instructions on pages 19 to 21.

4)Make gas connections, page 21. Test the pilot. Must be as per diagram, page 29.

5)If necessary, convert to Propane (page 22) or convert to lower Btu rating (page 23).

6)Test Gas Pressure, page 23.

7)Install log set, see page 24.

8)Install Front Door Front, page 25.

9)Install optional Remote Control, or Wall Ther- mostat, page 26.

10)Final check, page 27.

Before leaving this unit with the customer, the installer must ensure that the appliance is firing correctly and operation fully explained to customer.

This includes:

1)Clocking the appliance to ensure the cor- rect firing rate (rate noted on label) after burning appliance for 15 minutes.

2)If required, adjusting the primary air to ensure that the flame does not carbon. First allow the unit to burn for 15-20 min. to stabilize.

CAUTION: Any alteration to the product that causes sooting or carboning that results in damage is not the responsibil- ity of the manufacturer.

CLEARANCES TO

COMBUSTIBLES

The clearances listed are MINIMUM distances. Measure the clearance to both the appliance and the chimney connector. The farthest distance is correct if the two clearances do not coincide.

For example, if the appliance is set as indicated in one of the figures but the connector is too close, move the stove until the correct clear- ance to the connector is obtained.

This appliance may be installed only with the clearances as shown in the situations pictured.

Do not combine clearances from one type of installation with another in order to achieve closer clearances.

This unit can be installed on a solid combustible surface like a wood floor. This unit can also be installed directly on carpeting or vinyl when the bottom pedestal cover plate (provided with unit) is installed.

Use the minimum clearances shown in the diagrams below:

U39-NG & U39-LP Clearances

A Side Wall to Unit

7-1/2" / 190 mm

B Back Wall to Unit

6" / 150 mm

E Side Wall to Unit

2" / 50 mm

U39-NG & U39-LP Reference

Dimensions

CBack Wall to Flue Centerline 11"/280 mm

DSide Wall to Flue Centerline 20-1/2"/521 mm

FSide Wall to Flue Centerline 11"/280 mm Minimum ceiling height is 36" / 914 mm from top of unit.

6

Regency U39 ULTIMATE Direct Vent Freestanding Gas Stove

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Ultimate U39 Unit Specifications RegencyTable of Contents Safety Label Copy of Safety Label for U39 Gas StoveSave These Instructions InstallationSpecifications Information for MobileGeneral Safety Information Installation ChecklistClearances to Combustibles Venting Introduction Louver InstallationInstallation Precautions Locating Your Ultimate GAS StoveExterior Vent Terminal Rigid Pipe Venting Components List 4DT-AJBRigid Pipe Venting Systems Alternate Horizontal Termination CapsHorizontal Terminations for All Venting Systems Safety Precautions for the InstallerRigid Pipe Venting Arrangements Vent Restrictor PositionHorizontal Venting with Two 2 90o Elbows Vertical Venting with Two 2 90o ElbowsOptional DV Stove Horizontal Vent KITQty. Description Sions on pages 8 toDismantle all pipe sections including vent terminal Brick, concrete, or other types of sidingsDURA-VENT Termination KIT Planning Your Dura-Vent InstallationMinimum components for a Dura-Vent Horizontal Installation DURA-VENT Venting ComponentsDURA-VENT Horizontal Installations Snorkel TerminationsBelow Grade Installation Offset Chart Cathedral CeilingsSupport Extensions Round Rdse or Square Sqse GeneralConverting a Factory Built Metal Chimney Converting a Masonry Chimney System Data U39 with 40,000 BTU GAS ConnectionHigh Elevation System DataPilot assembly is now accessible for steps Conversion from Natural GAS to PropaneGAS Pipe Pressure Testing Conversion to Lower BTU RatingValve Description U39 with 38,000 Btu/h Aeration AdjustmentLOG SET Installation U39 with 30,000 Btu/hFront Door Installation Packaged separatelyWiring Optional Remote ControlOptional Wall Thermostat Operating Instructions Automatic Convection FAN Operation Adjusting Flame HeightNormal Operating Sounds GAS Appliances Copy of the Lighting Plate instructionsGeneral Vent Maintenance MaintenanceMaintenance Instructions GOLD-PLATED DoorsGlass Replacement LOG ReplacementLatch Adjustment Door GasketTo remove U39 fan FAN MaintenanceAlternate Fan Access Replacing U39 FanRemoving Valve Parts List U39 Main AssemblyDescription U39 Burner & LOG Assembly U39 Door Assemblies Regency U39 Ultimate Direct Vent Freestanding Gas Stove Regency U39 Ultimate Direct Vent Freestanding Gas Stove Regency U39 Ultimate Direct Vent Freestanding Gas Stove Warranty ConditionsInstaller Please complete the following information

U39-NG, U39-LP specifications

The Regency U39-LP and U39-NG are modern gas fireplaces designed to enhance the aesthetic appeal and functionality of any space while delivering exceptional performance. These units are part of Regency's commitment to innovation and sustainability, providing homeowners with an efficient heating solution that seamlessly integrates into various home styles.

One of the standout features of the U39 series is its versatility in fuel options. The U39-LP operates on liquid propane, while the U39-NG utilizes natural gas. This flexibility allows homeowners to choose the best option suited for their existing infrastructure and personal preferences. Both models are designed to deliver efficient heating with an impressive BTU output, ensuring that rooms stay warm and comfortable during colder months.

The U39 series is equipped with cutting-edge technologies, including a state-of-the-art control system that allows users to easily adjust the flame height and heat output. This feature not only enhances user convenience but also promotes energy efficiency by allowing adjustments based on real-time heating needs. The inclusion of an optional remote control further simplifies the operation, enabling users to manage their fireplace from anywhere in the room.

Another remarkable aspect of the Regency U39-LP and U39-NG is the clean, contemporary design. The linear shape and large viewing area provide an unobstructed view of the flames, adding a stunning focal point to any living space. The customizable options for finishes and surround materials mean that homeowners can tailor the fireplace to perfectly match their décor, whether it be modern, traditional, or somewhere in between.

Safety is a top priority for Regency, and the U39 series includes multiple safety features to ensure peace of mind. An integrated safety shut-off system is designed to automatically turn off the unit in case of emergencies, while tempered glass doors protect against accidental burns.

In summary, the Regency U39-LP and U39-NG gas fireplaces embody a blend of functionality, beauty, and safety. With their high thermal efficiency, user-friendly technologies, and elegant design, these fireplaces are an ideal choice for anyone looking to elevate their home heating experience while enjoying the charm of a glowing fire. Whether it's for a cozy gathering with family or a quiet evening alone, the U39 series stands out as a stylish solution with exceptional performance.
Top Page Image Contents