Wayne JSU50 operating instructions Air pressure check for pre- charged tanks, Friction loss chart

Operating Instructions & Parts Manual JSU50

Maintenance (Continued)

pre-charged TANKS

If a pre-charged tank becomes water- logged, the bladder is probably leaking or broken.

1.Test the tank by depressing the air valve. The valve will discharge water if the bladder is broken.

2.If bladder is broken, replace tank.

Once a tank bladder is ruptured, the tank should be replaced. Repairing the bladder is not recommended, and may cause further problems such as: repeated water-logging, debris in pipes and clogged discharge in tank.

air pressure check for pre- charged tanks

Small amounts of air loss is normal in any tank. To prevent failure and properly maintain a pre-charged water tank, check the pressure on a yearly basis.

1.Disconnect power to pump.

2.Open a faucet nearest the tank and allow all water to drain from the tank.

3.Measure the tank pre-charge at the valve stem using a tire gauge.

4.If necessary, adjust the pre-charge with an air pump: Precharged pressure for the this pump is 28-30 psi.

5.Prime the pump.

6.Reconnect power.

7.Close faucet.

RECOMMENDED FUSING & WIRING DATA - 60 HZ MOTORS

HP

VOLT

Dual

Element

Fuse 250V

Distance in Feet

From Meter to Motor

0	51		101	201
to	to		to	to
50	100		200	300
		Wire Size

1/2

115	15	14	12	10	8
230	10	14	14	14	14

				friction loss chart
			Feet Friction Loss in 100 Feet of Plastic Pipe
				Gallons Per Minute
Pipe Size	20	25	30	40	50	60	80	100	120
1-1⁄4”	5.6	8.5	11.9	20.2	30.5
1-1⁄2”	2.6	4.0	5.5	9.4	14.3	19.9	34.2
2“	1.2	1.6	2.8	4.2	5.8	9.9	15.0	21.2
2-1⁄2“				1.2	1.8	2.5	4.2	6.3	8.8

www.waynepumps.com

5