Wayne 353501-001 specifications WSS10, WSS20, WSS30, Operation Primary Pump

WSS10, WSS20, WSS30

WSS20		Grounded
Grounded		Outlet
Outlet
		Discharge pipe
Inlet pipe		24
		inch min.
	Check valve
	(not shown)
	12 inch	Cap Switch
	Diameter	ON @ 8 inches
Figure 1 (b)	min.	OFF @ approx. 3 inches
WSS30		Grounded
Grounded
		Outlet
Outlet

Discharge pipe

Inlet pipe			24
			inch min.
	Check valve
	15 inch		Cap Switch
Figure 1 (c)	Diameter		ON @ 8 inches
	min.		OFF @ approx. 3 inches
Installation (continued)		7.	Protect electrical cord from sharp
			objects, hot surfaces, oil and
	If cables are
			chemicals. Avoid kinking the
	reversed, damage to		cord and replace damaged cords
the control box or battery could result			immediately.
and will void the warranty.		8.	A sump pit cover must be installed
5. Place battery box within six feet of
			to prevent debris from clogging or
the sump and a 115 VAC separately
			damaging the pump.
fused outlet. The outlet must
be protected by a ground fault		Operation - Primary Pump
circuit interrupter (GFCI). The area
must also be clean, dry and well-			Always
ventilated.
		disconnect the power source
6. Plug the float switch, pump and
		before attempting to install,
charger into the control box. The		service, relocate or maintain
connections are marked on the		the pump. Never touch sump
control box.		pump, pump motor, water or discharge
		piping when pump is connected to

electrical power. Never handle a pump or pump motor with wet hands or when standing on wet or damp surface or in water. Fatal electrical shock could occur.

1.A ground fault circuit interrupter (GFCI) is required (see Figure 2).

Figure 2

Risk of electrical shock! This pump

is supplied with a grounding conductor and grounding type attachment plug. Use a grounded receptacle to reduce the risk of fatal electrical shock.

Never cut off the round grounding prong. Cutting the cord or plug will void the warranty and make the pump inoperable.

2.The primary pump is only for use on 120 volt (single phase), 60 hz, 15 amp service and is equipped with a 3-conductor cord and

3-prong, grounding type plug. Insert the switch cord plug directly into a 120-volt outlet.

3.Insert the pump power cord plug directly into the back of the water sensor cord plug.

4.Fill sump with water. The pump will start automatically when the water is about 1-1/2 inches from the top of the switch. The pump will recycle thereafter as required.

•Sump pump will run a minimum of 4 seconds, to a maximum of 16 before stopping.

•Sump pump run time will be determined by the sump pit size and water flow rate into the sump pit.

•Under flooding conditions, the sump pump will stop for 1 second, every 16 seconds, and automatically turn back on.

5.Do not operate the pump unless it is submerged in water. Dry running causes pump failure.

www.waynepumps.com

3