PB Heat Gas Boiler manual For Your Safety Read Before Operating, Lighting and Operating Procedures

Page 33

START-UP PROCEDURES

B.LIGHTING AND OPERATING PROCEDURES

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury or loss of life.

A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppliers’ instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to turn the gas control knob. Never use tools. If the handle will not turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

11. STOP! Read the safety information above.

12. Set the thermostat to lowest setting.

13. Turn off all electric power to the appliance.

14. This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

15. Remove front cover.

16. Turn gas shutoff valve clockwise to “off”. Handle will be vertical, do not force.

17. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “B” in the safety information above on this label. If you don’t smell gas, go to next step.

18. Turn gas shutoff valve counterclockwise to “on”. Handle will be horizontal

19. Install Front Cover.

10.Turn on all electric power to appliance.

11.Set thermostat to desired setting.

12.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electric power to the appliance if service is to be performed.

3.Remove front cover.

4.Turn gas shutoff valve clockwise to “off”. Handle will be vertical. Do not force.

5.Install front cover.

31

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Peerless Pinnacle Table of Contents Using this Manual Installation SequenceSpecial Attention Boxes General Accessibility Clearances PreinstallationCodes & Regulations Combustion and Ventilation AIRAccessibility Clearances Floor Standing Units General Boiler SET-UPWall Hung Boilers Floor Mounted BoilersWater Piping and Controls Operating ParametersSystem Components Boiler Inputs and Outputs Net I=B=R Output Model Btu/hr kW Piping Symbol KeyFeet meters Flow Rate and Pressure Drop Boiler ModelRecommended Circulators Boiler Grundfos CirculatorPinnacle Circulator Sizing Graph System Piping Freeze ProtectionOne Boiler, Primary/Secondary with Two Zones Zone Circulator Water Piping and Controls Water Piping and Controls Water Piping and Controls Three Boilers, Primary/Secondary with Four Zones Zone Valves Special Applications Boiler in conjunction with a Chilled Water System GAS Piping GAS Supply Piping InstallationFuel Line Sizing Feet PipeGas Supply Piping Sediment Trap GAS Supply Piping OperationMain GAS Valve Operation Recommended Vent CO² Settings Firing Gas Type RateExhaust Vent / AIR Intake Pipe Location Approved Materials for Exhaust Vent and Intake AIR PipeFitting Equivalent Length Table Fitting Description Exhaust Vent and Intake AIR Pipe SizingVent Termination Kits Stock Description Code Exhaust Vent and AIR Intake Pipe InstallationVENTING, Inlet AIR and Condensate PI-T50 & PI-T80 Sidewall Venting with 2 Pipe 2 Vent Kit With 2 Pipe With 2 Pipe Concentric Vent Kit Venting with 3 Pipe Venting with 3 Pipe Concentric Vent KitCondensate Drain Installation Exhaust Tapping for Vent SampleBoiler Removal from Common Venting System Wiring ElectricalSequence of Operation Boiler Control Board Wiring Schematic Control Functions Safety InterlocksStatus Menu Description Code Installer Menu Parameter FunctionCompleting the Installation START-UP ProceduresLighting and Operating Procedures For Your Safety Read Before OperatingCHECK-OUT Procedure Troubleshooting Boiler ErrorBoiler Fault Fault Code Description Corrective Action P125 Control Board Fault CodesGeneral with Boiler in USE MaintenanceWeekly with Boiler in USE Annually Before Start of Heating SeasonGAS Leaks Reset thermostats Important Make Boiler Dimensions Boiler Dimensions & RatingsPI-80/PI-140/PI-199 Dimensions Sch 40 PVC LbsRepair Parts Repair Parts Appendix A. WHAT’S NEW with the P125 Control Board Advantages of the P125 Control BoardP125 Control Board Quick Reference Figure A.2Comparative Control Board Sequence of Operation P125 Control Board VS. WHA Control Board ComparisonPeerless Pinnacle

Gas Boiler specifications

PB Heat Gas Boilers are renowned for their efficiency, reliability, and advanced technology, making them a popular choice for residential heating needs. With a range of models available, these boilers cater to various heating requirements while maintaining high performance and energy efficiency.

One of the standout features of PB Heat Gas Boilers is their exceptional efficiency ratings. Most models are designed to achieve AFUE (Annual Fuel Utilization Efficiency) ratings of over 90%, ensuring minimal energy waste and lower utility bills for homeowners. This high efficiency not only translates to cost savings but also contributes to a reduced carbon footprint, making PB Heat boilers a sustainable choice for environmentally conscious consumers.

PB Heat utilizes cutting-edge technologies to enhance the performance of their gas boilers. One such technology is the dual-stage gas valve, which allows for better modulation of gas flow, enabling the boiler to adapt to varying heating demands. This feature ensures consistent comfort while minimizing unnecessary energy consumption. Additionally, many PB Heat models come equipped with smart controls that can be easily integrated with home automation systems, giving homeowners the ability to monitor and adjust their heating remotely for maximum convenience and efficiency.

Durability and ease of maintenance are also key characteristics of PB Heat Gas Boilers. Constructed from high-quality materials, these boilers are designed to withstand the rigors of day-to-day operation. Features such as a corrosion-resistant heat exchanger contribute to the longevity of the unit, while easily accessible components simplify routine maintenance tasks, reducing downtime and service costs.

PB Heat Gas Boilers are available in various configurations, including wall-mounted and floor-standing models, catering to different space and installation requirements. This versatility allows homeowners to choose a solution that best fits their living environment while ensuring optimal heating performance.

In conclusion, PB Heat Gas Boilers represent a blend of advanced technology, energy efficiency, and robust construction. With their high efficiency ratings, smart control options, and durable design, these boilers provide reliable heating solutions for homes of all sizes. Choosing a PB Heat Gas Boiler means investing in a product that not only delivers comfort but also aligns with energy-saving and sustainability goals.
Top Page Image Contents