Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much.
Remote Control Control Panel | 1 If necessary, press the | (On/Off) button. |
| |||
|
|
| ||||
|
|
| Result: | The air conditioner starts up in the Cool mode. | ||
|
|
| ||||
|
|
|
| The unit beeps. | ||
|
|
|
| The air conditioner is fitted with a protection mechanism to pre- | ||
|
|
|
| vent the unit from being damaged when it is started immediately | ||
|
|
|
| |||
|
|
|
| after being: |
|
|
|
|
|
| Plugged in |
|
|
|
|
|
| Stopped |
|
|
|
|
|
| It will start up normally after three minutes. |
2If the temperature is not displayed at the top of the control panel, press
the Cool/Dry/Fan | button on the control panel one or more times until it | ||
| Mode |
|
|
appears. | The unit beeps each time you press the Cool/Dry/Fan button. | ||
Result: | |||
|
|
| Mode |
|
| The air conditioner runs in Dry mode. | |
|
| You can change modes at any time. |
3 To adjust the temperature, press the or buttons one or more times until the required temperature is displayed.
Possible temperatures are between 18C and 30C inclusive.
Result: | Each time you press the | or | buttons: |
- The temperature is adjusted by 1C - The unit beeps
The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically.
4To control the direction of the air flow, refer to page 11.