Agilent Technologies 6834B, 6814B Voltm Fixed, Step Slewm, Slewt, Slewm Pulse, Dcycle PER

Front Panel Operation - 4

	Example	Display
ϕ	This example uses the immediate slew rate. First, access the Voltage menu	VOLT:M		FIXED
	and press  until you access the mode command. On the Entry keypad, press
	° to obtain FIXED. Press Enter.
	Access the voltage menu and press  until you access the slew command. On	SLEW		50
	the Entry keypad, press 5 0 Enter to program a slew rate of 50 volts/second.
	Whenever a new immediate voltage value is entered, the output will slew to
	the new level at 50 volts/second.
	Step mode uses the triggered slew rate. First, access the Voltage menu,	VOLT		120
	program the immediate and triggered voltage levels, and set the slew mode to	VOLT:T		150
	STEP.	SLEW:M		STEP
	Access the Voltage menu and press  to access the immediate slew	SLEW:	9.9+E37
	command. On the Entry keypad, enter a value that equals infinity.
	Access the Voltage menu and press  until you access the triggered slew	SLEW:T		50
	command. On the Entry keypad, enter a value such as 5 0 Enter, which sets
	the triggered slew rate to 50 volts/second.
	Then press Trigger Control and Enter, followed by Shift Trigger.	INIT:IMMED
	After the trigger has been sent, in step mode, the triggered value becomes the
	new immediate value.
 Pulse mode uses the triggered slew rate at the leading edge of the pulse, and		VOLT		120
	the immediate slew rate at the trailing edge of the pulse. First, access the	VOLT:T		150
	Voltage menu, program the immediate and triggered voltage levels, and set	SLEW:M		PULSE
	the slew mode to PULSE.
	Access the Pulse menu and program the pulse count, duty cycle, and pulse	COUNT 2
	period.	DCYCLE		33
		PER	.0166
	Access the Voltage menu and press  to access the immediate slew	SLEW:	9.9+E37
	command. On the Entry keypad, enter a value that equals infinity.
	Access the Voltage menu and press  until you access the triggered slew	SLEW:T		50
	command. On the Entry keypad, enter a value such as 5 0 Enter, which sets
	the triggered slew rate to 50 volts/second.
	Then press Trigger Control and Enter, followed by Shift Trigger.	INIT:IMMED

When the voltage slew mode is set to LIST, the slew rates are set by the values in the voltage slew list. Refer to the List Transient example for more information on how to program lists. You must program the voltage values and dwell times as explained in that example. You must also program a slew rate for each point in the list (even if it is 9.9+E37).

NOTE: When specifying a dwell time, you must take the slew time into consideration. If the dwell time at any given list point is less than the slew time at the same point, the voltage will never reach its programmed level before the next list point becomes active.

51