Integra DTR-5.3 instruction manual Remote controller

Page 13

Remote controller

INPUT SELECTOR buttons [43, 44, 52]

Press to select an input source.

Same as the input selector buttons on the front panel of the DTR-6.3/

5.3.The input source for each button is given here. DVD:DVD, CD:CD, V1:VIDEO1, V2:VIDEO2, V3:VIDEO3, V4:VIDEO4, V5:VIDEO5 (not used with the DTR-6.3/5.3), TAP:TAPE, TUN:FM/AM, PH:PHONO (not used with the DTR-5.3).

Numeric key/Listening mode, SP A, SP B, CINE FLTR, Display, Dimmer buttons

1 to 9, +10, --/---, 0: For entering the number of a track. [63–65]

Pure A:

DTR-5.3:Not used with the DTR-5.3.

DTR-6.3:Press to select the Pure Audio mode. [50]

Direct, Stereo, SURR, All ST, DSP: You can select a listening mode. [50]

Note:

During playback of a multichannel source, press the Direct button to turn off the tone control and the SURR button to turn on the tone control. [47]

SP A, SP B:

DTR-5.3:Switches between speakers A and B. [44]

DTR-6.3:Not used with the DTR-6.3.

CINE FLTR: Depending on the listening mode, you can turn the CinemaFILTER function on or off. [51]

Display: For changing the display in the front display. [47]

Dimmer: Adjusts the display brightness.

There are three settings available: normal, dark, and very dark.

Light button

Press to turn on and off the lights in the buttons of the remote controller.

Setup button [37]

Press to display the Setup Menu on the TV screen and in the display. Press again to exit the menu.

///, ENTER button [37]

When in the Setup Menu, press the upper and lower arrow buttons to select an item, press the right and left arrow buttons to select parameter values or modes, and press the ENTER button to advance to the next item.

VOL button [43, 44]

Press to adjust the volume.

Test/Menu button

This button is used to set the speaker output levels. Use this button in conjunction with the Level / and CH SEL buttons to calibrate the speakers levels without entering the Setup Menu. [40]

When the DVD mode is selected, press to display the DVD menu (Menu). [64]

Muting button [47]

Press to activate the mute function.

Zone 2/Search/Enter button

When the DVD mode is selected, press to find the specific section on a DVD where you want to start playback (Search). [64]

DTR-6.3:When in the RCVR mode, press to perform operations on the remote zone (Zone 2). [59]

DTR-5.3:Switches the audio signal output to the A-BUS keypad. [28]

When in the MD mode, press to enter the selected song (Enter). [65]

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents DTR-6.3/5.3 Avis Important SafeguardsPrecautions Contents Contents DTR-6.3 Amplifier Features FeaturesBefore using this unit Supplied accessoriesInstalling the remote controller batteries Using the remote controllerDTR-6.3 DTR-5.3 Front panel facilitiesFront panel facilities Speakers A/B buttons DTR-5.3 only Listening mode or digital input format indicators Muting indicatorTuning indicators Sleep indicatorRemote controller Remote controller Connections Connections Connecting a compact disc player CD Connecting your audio componentsConnecting a turntable Phono Signal flowConnecting a DVD Player with 5.1-Channel Output Connecting your video componentsFlow of the video signals is as follows Connections DTR-6.3Connecting a DVD player DVD Connecting a DVD Player with 2-Channel L/R Audio OutputVideo Connecting a video cassette recorder VideoMonitor OUT Connecting a television monitor or projector Monitor OUTPower amplifier Connecting video camera, etc. Video 4 InputFront right speaker Front left speaker Center speakerWhen using the Zone 2 PRE OUT terminals Connecting the remote zone Zone 2 speakersWhen using the Zone 2 Speakers terminals When using the Zone 2 OUT terminalsCD player CD Connections DTR-5.3Video output Connections DTR-5.3Connections DTR-5.3 Video 2/3 Video output Digital output Optical Connections DTR-6.3/5.3 Power cord supplied To an AC wall outletDTR-6.3/5.3 12V Trigger OUT A/B DTR-6.3 only 12V Trigger OUT ZONE2Power off function Power on/ready functionDirect change function DTR-6.3 only From connecting blockOther component Standard speaker setup for surround sound Connecting speakersMinimum speaker configuration for surround sound playback Speaker placementConnecting speakers Connecting speakersConnecting a subwoofer Connecting to the Speakers B terminals DTR-5.3 onlySubwoofer Surround Front Center Right Speaker LeftRight Back Left Speaker Turning on the power from the remote controller Connecting the powerTurning on the power Connecting the AM antenna cable Connecting antennasConnecting the included antennas Assembling the AM loop antennaConnecting an FM outdoor antenna Connecting antennasConnecting an AM outdoor antenna Directional linkageSpeaker Configuration Configuring the speakersDisplaying the Main Menu Adjustable Crossover 80/100/120 Hz for Bass Management Configuring the speakersFeet Select if you will enter the distances in feet Calibrating the speaker levelsMeters Select if you will enter the distances in meters Use the and cursor buttons to select LeftPress the Test button to complete the procedure Using the remote controller Press the Test buttonButtons used for navigating through the menus Tuning into a radio station Listening to a stereo radio station FM modeFM Mode Tuning Tuner Listening to Radio BroadcastsSelecting a preset radio station Presetting a radio stationErasing a preset radio station Listening to Radio BroadcastsSelecting an Audio Component Adjust the volume to an appropriate levelBasic operation DTR-6.3 Press the desired input sourceBasic operation DTR-5.3 Selecting an Audio ComponentSelecting speakers Speakers A, B DTR-5.3 only Speakers A/BTemporarily changing the speaker output levels Selecting the type of audio input signalTo change the display of the input source from Tape to MD Listening with headphones Using the sleep time remote controller onlySleep Audio Adjust Enjoying DVD multichannel audio playbackTemporarily turning off the sound Switching the displayListening Modes Listening Modes Rcvr Mode Listening mode buttons Selecting a listening modeTip While playing back Dolby Digital 2-channel sourcesOriginal filter CinemaFILTER loading for movies Press the Cine Fltr button on the remote controllerReturn Menu Input source buttons Return Setup Input SetupInput Selector buttons Digital Input Input SetupDigital Format MultichannelAnalog/PCM Source IntelliVolumePCM fs96kHz Source Digital Format SourceOSD Setup OSD Setup and Other SettingsTo display the OSD Setup menu PreferenceSetup Procedure Press the Audio Adjust button Audio AdjustSetting Values Initial value Bass, TrebleAudio Adjust Late Settings possible for each listening modeAdjusting the volume for the remote zone Using the buttons on the DTR-6.3Ex. When the CD button is pressed Adjusting the volume using the remote controllerRec Out Off Input source buttons Recording a source DTR-6.3Start recording at the recording component as desired Recording a source DTR-5.3 Calling up a preset radio station Using remote controllerRcvr Mode VOL Muting Controlling an Onkyo cassette tape deckPress the CD Mode button Using remote controllerControlling an Integra/Onkyo CD player Press the DVD Mode button Top Menu Audio SEL Angle Standby DVD Mode SetupControlling an Integra/Onkyo DVD player Controlling an Integra/Onkyo MD recorder Press the MD Mode buttonTo 9, 0, --/--- Numeric keys Learning a pre-programming code Entering a pre-programming codeWithin 30 seconds, enter the 3-digit code number Pre-programming codes Entering a pre-programming codeDVD Mode DVD Player Mode Operating your programmed remote controllerVCR Mode VCR Mode TV Mode TV ModeIndicator Mode buttons Enter Programming procedureSend/Learn To 6 inches To 15 cmPage Erasing all the commands programmed under a Mode button Erasing the programmed command from one buttonSend/Learn indicator Mode buttons Enter Press and release the same Mode button againProgramming the macro Using the macro functionExecuting the macro Erasing all commands and macros that have been programmed Using the macro functionErasing a macro from the Macro 1 or 2 button Macro Macro mode programming memoTroubleshooting guide Video and Audio Troubleshooting guideIf one of the messages shown below appears Amplifier Section Specifications DTR-6.3Specifications DTR-5.3 Onkyo U.S.A. Corporation
Top Page Image Contents