Integra DTR-5.3 instruction manual Connecting the remote zone Zone 2 speakers, DTR-6.3 only

Page 22

Connecting the remote zone (Zone 2) speakers

(DTR-6.3 only)

The DTR-6.3 allows you to listen to two separate input sources at the same time. This allows you to, for example, place speakers in two different rooms so that two or more people can enjoy two different kinds of music at the same time. The room where the DTR-6.3 is actually located is referred to as the main room while the separate room is referred to as the remote zone (Zone 2). In addition, the IR IN terminal of the DTR-6.3 allows you to control the DTR-6.3 from

When using the ZONE 2 PRE OUT terminals

If you are using a 5.1-channel speaker system in the main room, you can connect the amplifier for the remote zone (Zone 2) to the open ZONE 2 PRE OUT terminals and connect the remote zone speakers.

the remote zone (Zone 2) with the remote controller even though the remote zone is physically separated. The diagram below shows how to make the proper connections for the remote zone.

When using the ZONE 2 SPEAKERS terminals

If you are using a 5.1-channel speaker system in the main room, you can connect the speakers for the remote zone (Zone 2) to the open ZONE 2 SPEAKERS terminals.

Main Room	Remote Zone (Zone 2)
	Zone 2	Zone 2
	Left	Right
	speaker	speaker

Main Room

DTR-6.3

FRONT SURROUND CENTER ZONE 2

L L

PRE OUT

R R

SURROUND

BACK

Left (white)

Right (red)

Remote Zone (Zone 2)

	Zone 2			Zone 2
	Left			Right
speaker				speaker

Power amplifier

ZONE 2

SPEAKERS

L

R

DTR-6.3

Note:

It is important to be aware of the speaker impedance (see page 32).

When using the ZONE 2 OUT terminals

The ZONE 2 OUT terminal is a constant output. Connect to the LINE input of the amplifier (CD, tape, etc.). Adjust the volume with the amplifier connected to the ZONE 2 LINE OUT terminal.

1.Connect the DTR-6.3 to the amplifier for the remote zone.

2.Connect the remote zone speaker cables to the speaker terminals on the amplifier.

Adjust the volume level at the amplifier.

Remote Zone (Zone 2)

Zone 2	Zone 2
Left	Right
speaker	speaker

	Zone 2 amplifier
	M		R	PHONO IN	Main Room
			R	L	Main Room
				RS232
Left (white)				ZONE 2
Left (white)	ZONE 2	DC IN	LINE OUT
	OUT	24V 1A		L
				L
				R
Right (red)					DTR-6.3

Note:

The ZONE 2 OUT terminals of the DTR-6.3 are of a fixed output level.

22

Image 22

Contents DTR-6.3/5.3 Important Safeguards AvisPrecautions Contents Contents Features DTR-6.3 Amplifier FeaturesInstalling the remote controller batteries Supplied accessoriesBefore using this unit Using the remote controllerFront panel facilities DTR-6.3 DTR-5.3Front panel facilities Speakers A/B buttons DTR-5.3 only Tuning indicators Muting indicatorListening mode or digital input format indicators Sleep indicatorRemote controller Remote controller Connections Connections Connecting a turntable Phono Connecting your audio componentsConnecting a compact disc player CD Signal flowFlow of the video signals is as follows Connecting your video componentsConnecting a DVD Player with 5.1-Channel Output Connections DTR-6.3Connecting a DVD Player with 2-Channel L/R Audio Output Connecting a DVD player DVDConnecting a video cassette recorder Video VideoConnecting a television monitor or projector Monitor OUT Monitor OUTFront right speaker Connecting video camera, etc. Video 4 InputPower amplifier Front left speaker Center speakerWhen using the Zone 2 Speakers terminals Connecting the remote zone Zone 2 speakersWhen using the Zone 2 PRE OUT terminals When using the Zone 2 OUT terminalsConnections DTR-5.3 CD player CDConnections DTR-5.3 Video outputConnections DTR-5.3 Video 2/3 Video output Digital output Optical DTR-6.3/5.3 12V Trigger OUT A/B Power cord supplied To an AC wall outletConnections DTR-6.3/5.3 DTR-6.3 only 12V Trigger OUT ZONE2Power off function Power on/ready functionDirect change function DTR-6.3 only From connecting blockOther component Minimum speaker configuration for surround sound playback Connecting speakersStandard speaker setup for surround sound Speaker placementConnecting a subwoofer Connecting speakersConnecting speakers Connecting to the Speakers B terminals DTR-5.3 onlySubwoofer Surround Front Center Right Speaker LeftRight Back Left Speaker Turning on the power from the remote controller Connecting the powerTurning on the power Connecting the included antennas Connecting antennasConnecting the AM antenna cable Assembling the AM loop antennaConnecting an AM outdoor antenna Connecting antennasConnecting an FM outdoor antenna Directional linkageSpeaker Configuration Configuring the speakersDisplaying the Main Menu Configuring the speakers Adjustable Crossover 80/100/120 Hz for Bass ManagementMeters Select if you will enter the distances in meters Calibrating the speaker levelsFeet Select if you will enter the distances in feet Use the and cursor buttons to select LeftPress the Test button to complete the procedure Using the remote controller Press the Test buttonButtons used for navigating through the menus FM Mode Tuning Tuner Listening to a stereo radio station FM modeTuning into a radio station Listening to Radio BroadcastsErasing a preset radio station Presetting a radio stationSelecting a preset radio station Listening to Radio BroadcastsBasic operation DTR-6.3 Adjust the volume to an appropriate levelSelecting an Audio Component Press the desired input sourceSelecting speakers Speakers A, B DTR-5.3 only Selecting an Audio ComponentBasic operation DTR-5.3 Speakers A/BTemporarily changing the speaker output levels Selecting the type of audio input signalTo change the display of the input source from Tape to MD Sleep Audio Adjust Using the sleep time remote controller onlyListening with headphones Enjoying DVD multichannel audio playbackSwitching the display Temporarily turning off the soundListening Modes Listening Modes Tip Selecting a listening modeRcvr Mode Listening mode buttons While playing back Dolby Digital 2-channel sourcesPress the Cine Fltr button on the remote controller Original filter CinemaFILTER loading for moviesReturn Menu Input source buttons Return Setup Input SetupInput Selector buttons Digital Format Input SetupDigital Input MultichannelPCM fs96kHz Source IntelliVolumeAnalog/PCM Source Digital Format SourceTo display the OSD Setup menu OSD Setup and Other SettingsOSD Setup PreferenceSetting Values Initial value Audio AdjustSetup Procedure Press the Audio Adjust button Bass, TrebleAudio Adjust Settings possible for each listening mode LateEx. When the CD button is pressed Using the buttons on the DTR-6.3Adjusting the volume for the remote zone Adjusting the volume using the remote controllerRec Out Off Input source buttons Recording a source DTR-6.3Start recording at the recording component as desired Recording a source DTR-5.3 Rcvr Mode VOL Muting Using remote controllerCalling up a preset radio station Controlling an Onkyo cassette tape deckPress the CD Mode button Using remote controllerControlling an Integra/Onkyo CD player Press the DVD Mode button Top Menu Audio SEL Angle Standby DVD Mode SetupControlling an Integra/Onkyo DVD player Controlling an Integra/Onkyo MD recorder Press the MD Mode buttonTo 9, 0, --/--- Numeric keys Learning a pre-programming code Entering a pre-programming codeWithin 30 seconds, enter the 3-digit code number Entering a pre-programming code Pre-programming codesVCR Mode VCR Mode Operating your programmed remote controllerDVD Mode DVD Player Mode TV Mode TV ModeSend/Learn Programming procedureIndicator Mode buttons Enter To 6 inches To 15 cmPage Send/Learn indicator Mode buttons Enter Erasing the programmed command from one buttonErasing all the commands programmed under a Mode button Press and release the same Mode button againProgramming the macro Using the macro functionExecuting the macro Erasing all commands and macros that have been programmed Using the macro functionErasing a macro from the Macro 1 or 2 button Macro mode programming memo MacroTroubleshooting guide Troubleshooting guide Video and AudioIf one of the messages shown below appears Specifications DTR-6.3 Amplifier SectionSpecifications DTR-5.3 Onkyo U.S.A. Corporation