Integra DTR-5.3 Listening to Radio Broadcasts, Listening to a stereo radio station FM mode

Listening to Radio Broadcasts

FM Mode Tuning/

Tuner

One of the features of the DTR-6.3/5.3 that is most frequently used is		Listening to a stereo radio station (FM mode)
its ability to play FM and AM broadcast radio stations. The DTR-
6.3/5.3 provides a number of listening modes perfect for listening to		When you tune into a radio station, TUNED
the radio and getting the most out of your audio system. Also, by		indicator appears in the display. If you tune into
presetting radio stations that you listen to frequently, you can select		an FM station in stereo, then “FM STEREO”
them easily by pressing the CH	button on the remote controller.	appears. If the signal is weak, it may be
		impossible to tune into the station in stereo. In
		such a case, press the FM Mode button on the
		front panel. The AUTO indication disappears
Tuning into a radio station
		and the radio station is output in the monaural
		mode. To return to stereo, press the FM Mode
1. Press the Tuner input source button.
		button again. “AUTO” appears. Some inter-
Each time you press the Tuner button, the		station noise may be heard, but the sound will
input source changes between AM and FM.		not cut in and out as it would if stereo was
		selected.

2. Using the Tuning and buttons on the front panel, tune into the station you desire.

“FM STEREO” Tuned

(Lights red) in stereo Auto mode

TUNED

FM STEREO AUTO

Band Frequency

•The tuner frequency changes in 50-kHz increments for FM and 10-kHz increments for AM.

•You can press the Tuning or button continuously for more than 0.5 seconds to scan for an FM station in the direction of the button you pressed (FM auto tuning mode). After you release the button and a station is received in stereo, the scanning stops.

41