Recoton/Advent U31-LP2, U31-NG2 Excalibur Surround Installation, Flanges Blanking Plate

INSTALLATION

EXCALIBUR SURROUND

INSTALLATION

IMPORTANT NOTE:

When using the Surround, the unit must be set 1" further into the fi replace than the standard faceplate installation. See the diagrams below for the correct minimum fi replace opening requirements.

2)Align the cut-outs in the Blanking Plate with the pins located on the inside top of the fi rebox. Slide the Blanking Plate into position ensuring it goes under the 2 fl anges.

C

L

29”

Flanges

16”

Blanking Plate

￿

21”

1) Align the left side Faceplate Trim Bracket with the Firebox Flange and secure using 2 screws as shown in diagram 1. Repeat for right side.

3)Hold the Faceplate Trim up against the unit in order to make the following wire connections.

Pull the ON/OFF connector wires from the fi rebox and connect them to the switch.

Connect the fan switch wires with the wire connectors from the fan speed control. Place clips over wires and tuck into side trim.

Faceplate Trim

Bracket

Firebox

Flange

wires to

ON/OFF switch

for gas

connection

ON/OFF

switch

Fan Speed

Switch

(Rear View)

wires to Fan switch connectors

Self-adhesive wire clip

FPI U31-2 Gas Fireplace Insert 19