INSTALLATION
3)Place the bottom of the fl ush glass behind the bottom glass trim.
4)Secure the glass with the two glass clips at the top corners of the glass. Secure glass clips with the screws provided. Do not over tighten as this could break the glass.
5)Slide in the top glass trim under the spring clips.
BAY FRONT
INSTALLATION
1)Place the bay door onto the 2 pins on the top of the unit.
2)Position 2 magnets on the back of each trim piece close to the ends. Place the top and bottom trim pieces on the bay front.
BAY LOUVERS
1)Install top louver by sliding the two bracket clips into the brackets located on top of the bay door. See below.The fitted louver leaves a small gap between faceplate bottom and louver top.
2) Install bottom louver by sliding the two |
bracket clips into the brackets located |
underneath the bay door and secure with |
FLUSH LOUVERS
1)The Top Louver is held in place by friction fi t, if the Louver needs to be adjusted; bend the bracket out as shown in the diagram.
2)Install the Spring Hinges on the left and right side of the bottom of the Firebox using 2 screws per hinge.
3)Place the Bottom Louver near the hinge. Flip hinge over the Bottom Louver and secure using 3 screws.
Hinge
Location
B o t t o m
3)Install top and bottom louvers.
Note: The top and bottom trim pieces are different, check diagrams above and below.
2 screws into the bracket on the bottom of |
the Bay Front as per diagram above. |
3) Slide the valve extension knobs onto the |
valve knobs. match the correct ext. knob |
with the valve knob. |
DOUBLE DOOR
SCREEN
1) Pull out the top louver and the top glass trim.
2) Loosen the screws so the glass clips can be turned aside and the flush glass re- moved.
FPI | 13 |