Integra DTR-5.6 instruction manual Preferences, IntelliVolume, Volume Setup

DTR-5.6.book Page 69 Thursday, September 22, 2005 5:07 PM

Advanced Setup—Continued

Preferences

This section explains items on the “Preference” menu.

Receiver

Enter

Setup

4	Use the Up and Down [	]/[	]
	buttons to select an option, and
	use the Left and Right [	]/[	]

buttons to change it.

The preferences are explained in the next column.

5	When you’ve finished, press the
	[Setup] button.
	Setup closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.

1	Press the [Receiver] Remote
	Mode button, followed by the
	[Setup] button.
	The main menu appears onscreen.

2	Use the Up and Down [	]/[	]
	buttons to select “7. Preference,”
	and then press [Enter].
	The Preference menu appears.
	7.Preference
	------------------------
	1.IntelliVolume
	2.Volume Setup
	3.OSD Setup
	4.OSD Position
	5.12V Trigger A Setup
	6.12V Trigger B Setup
	7.12V Trigger C Setup
	8.Lock Setup
3	Use the Up and Down [	]/[	]

buttons to select a preference, and then press [Enter].

IntelliVolume

With this preference, you can set the input level for each input source. This is useful if some of your components are louder or quieter than others.

Use the Up and Down []/[ ] buttons to select an input selector, and use the Left and Right [ ]/[ ] but- tons to set the level.

If a component is too loud compared to your other com- ponents, use the Left [] button to reduce its input level. If it’s too quiet, use the Right [ ] button to increase its input level. The level can be set from –12 dB to +12 dB.

Volume Setup

■Volume Display

With this preference, you can choose how the volume level is displayed.

Absolute:Display range is MIN, 1 through 99, MAX.

Relative:Display range is –∞dB, –81 dB, –80 dB through +18 dB.

The absolute value 82 is equivalent to the relative value 0 dB.

■Muting Level

This preference determines how much the output is muted when the Muting function is used (see page 52). It can be set to –∞dB (default) or between –50 dB and –10 dB in 10 dB steps.

■Maximum Vol / Z2 Maximum Vol

With these preferences, you can prevent the volume being set too high by specifying maximum volume levels for the main room and Zone 2.

When the “Volume Display” preference is set to “Abso- lute,” the range of “Maximum Vol” is 50 to 99 (“Z2 Max- imum Vol” is 50 to 81). When it’s set to “Relative,” the range of “Maximum Vol” is –32 dB through +17 dB (“Z2 Maximum Vol,” the range is –32 dB through –1 dB). To specify no maximum volume, select “Off.”

69