Integra DTR-5.6 instruction manual Using Zone, Controlling Zone 2 from the AV Receiver

DTR-5.6.book Page 75 Thursday, September 22, 2005 5:07 PM

Zone 2—Continued

Using Zone 2

This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2.

Controlling Zone 2 from the AV Receiver

1 2

1	To turn on Zone 2 and select an
	input source, press the [Zone 2]
	button repeatedly.

Alternatively, press the [Zone 2] button followed by an input selector button within 8 seconds.

Zone 2 turns on, the Zone 2 indicator lights up, and the ZONE 2 12V TRIG- GER OUT goes high (+12 V).

To select AM, FM, or XM (North American model only), press the [Tuner] input selector button repeat- edly.

To select the same source as that of the main room, press the [Zone 2] button repeatedly until “Zone 2 Sel: Source” appears.

2	To turn off Zone 2, press the
	Zone 2 [Off] button.

Controlling Zone 2 with the Remote Controller

Standby

On

Input

Selector

Zone2

Level–,

Level+

Note:

• To control Zone 2, you must press the remote control- ler’s [Zone 2] Remote Mode button first.

1	Press the [Zone 2] Remote Mode
	button, then point the remote
	controller at the AV receiver and
	press the [On] button.
	Zone 2 turns on, and the ZONE 2 12V
	TRIGGER OUT goes high (+12 V).
2	To select an input source for
	Zone 2, press the [Zone 2]
	Remote Mode button, followed by
	an Input Selector button.
	To select AM, FM, or XM, press the
	[Tuner] Input Selector button repeat-
	edly.

3	To turn off Zone 2, press the
	[Zone 2] Remote Mode button,

followed by the [Standby] button.

75