8.Wood burning tray
8.1In order to burn wood continuously in this appliance a Wood Burning Tray should be fitted (see Diagram 12).
12
8.2Remove the multi-fuel grate from the appliance (see Installation Instructions, Section 5).
8.2To fit the Wood Burning Tray:
—Remove the log bar.
—Hold the tray flat with the front edge pointing forwards (see Diagram 12).
—Tilt diagonally and insert through the front of the stove (see Diagram 13).
13
PR8863
—Place tray flat on the fixings on the firebed (see Diagram 14).
14
—Fit the plug supplied into the hole where the riddling mechanism is normally located and secure with bolt and clamp (also supplied, see Diagram 15).
15
ClampPlug
Bolt
PR8865
—Replace the log bar.
9.Extended burning
9.1It is possible to get the appliance to burn for extended periods of time. In order to do this:
—De-ash prior to final refuelling.
—Set air controls to low combustion settings.
This will gradually blacken the glass but it will clear when operated at a high temperature for a short period.
—Use smokeless fuel or small, thick logs.
10.OVER-FIRING
10.1Do not over-fill with fuel or run at high temperatures for long periods or over-firing can occur. If the flue pipe, flue collar or top plate glow red the appliance is over-firing. Close the air controls to reduce the temperature.
10.2Over-firing can cause permanent damage to the appliance.
